Miller MIGmatic M-25 Manual del usuario - Página 12
Navegue en línea o descargue pdf Manual del usuario para Accesorios de soldadura Miller MIGmatic M-25. Miller MIGmatic M-25 20 páginas. Air-cooled guns for gmaw and fcaw welding
También para Miller MIGmatic M-25: Manual del usuario (8 páginas), Manual del usuario (12 páginas)
Imprimir página
5-2. Replacing Switch And/Or Head Tube
1
Remove handle
locking nut.
4 Remove screw.
5
Secure head
tube in vice.
7
Install existing shock washer onto new head tube.
Hand-tighten head tube into cable connector.
Tools Needed:
3/4 in.
OM-227 796 Page 8
6
Loosen jam nut.
Remove from vice
and turn head tube
out by hand.
9
Remove from vice. Reposition handle and install
switch housing. Secure with handle locking nut.
10 Install screw.
9/64 in.
!
Turn Off welding power source
/wire feeder and disconnect gun.
3
Slide handle.
2
Remove switch housing. Install new switch and
connect leads (polarity is not important).
Reassemble in reverse order. If replacing head
tube, continue to end of figure.
8
Place head tube in vice and tighten until
nuts are tight.
Ref. 800 795-E