Miller MIGmatic M-25 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Miller MIGmatic M-25에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller MIGmatic M-25 20 페이지. Air-cooled guns for gmaw and fcaw welding
Miller MIGmatic M-25에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지), 소유자 매뉴얼 (12 페이지)

페이지 인쇄
Miller MIGmatic M-25 소유자 매뉴얼

5-2. Replacing Switch And/Or Head Tube

1
Remove handle
locking nut.
4 Remove screw.
5
Secure head
tube in vice.
7
Install existing shock washer onto new head tube.
Hand-tighten head tube into cable connector.
Tools Needed:
3/4 in.
OM-227 796 Page 8
6
Loosen jam nut.
Remove from vice
and turn head tube
out by hand.
9
Remove from vice. Reposition handle and install
switch housing. Secure with handle locking nut.
10 Install screw.
9/64 in.
!
Turn Off welding power source
/wire feeder and disconnect gun.
3
Slide handle.
2
Remove switch housing. Install new switch and
connect leads (polarity is not important).
Reassemble in reverse order. If replacing head
tube, continue to end of figure.
8
Place head tube in vice and tighten until
nuts are tight.
Ref. 800 795-E