Miller MIGmatic M-25 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Miller MIGmatic M-25에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller MIGmatic M-25 20 페이지. Air-cooled guns for gmaw and fcaw welding
Miller MIGmatic M-25에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지), 소유자 매뉴얼 (12 페이지)

페이지 인쇄
Miller MIGmatic M-25 소유자 매뉴얼
SECTION 5 − MAINTENANCE & TROUBLESHOOTING
5-1. Removing Nozzle, Contact Tip, And Adapter, Changing Liner, And Cleaning Gun
Casing
1
7/16 in.
Remove nozzle,
contact tip, and
adapter.
Tools Needed:
5/8, 7/16 in.
2
3
4
Head
Tube
5/8 in.
Blow out
gun casing.
3/4 in.
(20 mm)
Liner
Stickout
!
Turn off welding power
source/wire feeder.
1
Nozzle
2
Contact Tip
3
Tip Adapter
4
Nozzle Adapter
.
Wire size stamped on tip −
check and match wire size.
Cut off wire and
disconnect gun
from feeder.
Lay gun cable out
straight before
installing new liner.
Reassemble gun in
reverse order from
taking it apart.
.
Thread wire according to
welding power source/wire
feeder manual.
Unscrew and
remove liner.
Install
Liner
804 466-A
OM-227 796 Page 7