Miller RUNNING GEAR Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Accesorios de soldadura Miller RUNNING GEAR. Miller RUNNING GEAR 22 páginas.

SAFETY PRECAUTIONS

WARNING

To ensure continued safe operation, replace damaged or worn-out parts with

genuine Miller service parts, before attempting to operate equipment.

GREASING

It is well to remember that a sufficient amount of oil or grease will prevent

excessive part wear and early failure. Grease fittings are provided on the

running gear at several important pivot points. Fittings should be lubricated at

least four times a year. Use a good grade of lithium base grease. Wipe dirt from

the fittings before greasing to prevent any dirt from being forced into the bearings

or pivots. Replace any missing fittings. To minimize dirt build-up, avoid exces-

sive greasing.

NOTE: In addition to the fittings, inspect and repack the wheel bearings at least

twice a year. See "Wheel Bearings" on next page.

Grease Fitting Locations:

Drawbar vertical pivot

Front spindle pivot (each side)

Ball joints (4 places)

Drawbar horizontal pivot

Tandem pivot (each side on tandem units)

DECAL LOCATION