Miller Invision 352 MPa Auto-Line CE Manual del usuario - Página 39
Navegue en línea o descargue pdf Manual del usuario para Inversor Miller Invision 352 MPa Auto-Line CE. Miller Invision 352 MPa Auto-Line CE 44 páginas.
También para Miller Invision 352 MPa Auto-Line CE: Manual del usuario (48 páginas), Manual del usuario (44 páginas)
Imprimir página
8-4. Troubleshooting
Trouble
No weld output; unit completely inop-
erative.
No weld output; meter display On.
Erratic or improper weld output.
No 115 volts AC output at duplex
receptacle.
No 24 volts AC output at Remote 14
receptacle.
Notes
.
A complete Parts List is available at www.MillerWelds.com
Place line disconnect switch in On position (see Section 5-7).
Check and replace line fuse(s), if necessary, or reset circuit breaker (see Section 5-7).
Check for proper input power connections (see Section 5-7).
Input voltage outside acceptable range of variation (see Section 5-6).
Check, repair, or replace remote control.
Unit overheated. Allow unit to cool with fan On (see Section 4-7).
Use proper size and type of weld cable (see Section 5-2).
Clean and tighten all weld connections.
Check for correct polarity.
Reset supplementary protector CB1 (see Section 5-5).
Reset supplementary protector CB2 (see Section 5-5).
Remedy
OM-245171 Page 33