Aquasana AQ-7000 Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Sistemas de filtración de agua Aquasana AQ-7000. Aquasana AQ-7000 2 páginas. In-line refrigerator & fountain filtration system
También para Aquasana AQ-7000: Instrucciones de instalación (2 páginas)

Imprimir página

Turn off water supply to refrigerator

Turn on the incoming water supply and

flush the filter into a bucket. Run water for 2-3

minutes to flush out air. The initial surge of

Locate an easily accessible section of

water may be discolored due to carbon fines

refrigerator water supply tubing or supply line to

refrigerator from under-sink.

(See Figure 3).

FLOW

OUTLET TO

INLET FROM

REFRIGERATOR

SUPPLY LINE

If installing on the back of a

refrigerator; cut and remove a 11.5" section of

refrigerator water supply tubing. Use a tube cutter for

copper tubing and a utility knife for plastic tubing,

Make sure ends are square and free from nicks and

deep scratches.

(See Figure 1).

Correct

Incorrect

Figure 1

Referring to "Using Push-In Fittings"

section below, insert refrigerator water supply tubing

into inlet push-in fitting on filter(see Figure 2).

FLOW

Shut off water supply again. Referring

Figure 2

to "Using Push-In Fittings" section, insert water

supply tube from refrigerator into outlet fitting

(see Figure 4).

Using Push-In Fittings To Attach Tubing

Use plastic strap to secure filter to

Push tubing in as far as it will go. Tubing must be

back of refrigerator or undersink.

inserted past o-ring and hit backstop. Pull tube to

ensure it is secured.

Turn on water supply to refrigerator

and check for leaks.

BACKSTOP

To Release Tubing

Push in grey collet to release tubing. With collet

held, pull tubing straight out.

COLLET

Figure 4

FILTER REPLACEMENT

The contaminants or other substances removed or reduced by this water

filter are not necessarily in all user's water. Filter life varies depending on

local water conditions and the volume of water used. We recommend that

you change your filter every 6 months. However, it can be replaced earlier

if there is a drop in flow rate at the refrigerator's water dispenser (if pres-

ent) or if the icemaker's performance deteriorates.

Do not use with water that is microbiologically unsafe or of unknown

quality without adequate disinfection before or after the system.

FILTER REPLACEMENT INSTRUCTIONS

1. Turn off water supply to refrigerator.

2. Referring to section "Using Push-In Fitting", release tubing from both

ends of filter.

3. Referring to "Using Push-In Fittings" section, insert refrigerator water

supply tubing into inlet push-in fitting on filter.

4. Turn on the incoming water supply and flush the filter into a bucket.

Run water for 2-3 minutes to flush out air.

5. Shut off water supply again. Referring to "Using Push-In Fittings"

section, insert water supply tube from refrigerator into outlet fitting.

6. Turn on water supply to refrigerator and check for leaks.

TROUBLESHOOTING GUIDE

Water leaks at Push-in Connections: Push tubing in as far as it will go. If

leaking continues, shut off water at the original valve and remove water

line by pushing in on the connector collar while pulling the tubing away.

See, "Using Push-In Fitting" section. Inspect tubing for cracks and

scratches. If tubing is cracked or scratched, simply cut that portion away

Figure 3

and reinsert new end of tubing into fitting. Make sure tubing is cut straight.

If not, re-cut.

CONTACT

Contact customer service toll free in the U.S.A. And Canada

1-866-NO-BOTTLE(662-6885)

Monday through Friday 7:00 a.m to 7:00 p.m (CST) Saturday, 10:00

a.m. to 2 p.m (CST) or write us at:

Sun Water Systems

Customer Experience Center

6310 Midway Road

Haltom City, TX. 76117

Please include a daytime phone number in your correspondence.

FLOW

BEST SERVICE, BEST VALUE!

WATER 4 LIFE

AUTO-SHIP REPLACEMENT PROGRAM

Enroll Me Now!

Name______________________________________________________

Address____________________________________________________

____________________________________________________

City___________________ St/Prov____________ Zip_______________

Email______________________________________________________

Phone______________________________________________________

Credit Card Type________________ Expiration Date_____/_____/_____

Credit Card #________________________________________________

Signature_________________________________ Date______________

Date Purchased______/______/_________

Additional Shipping Charges apply for Canada, Hawaii, Alaska.

TX residents must pay an additional 8.25% sales tax.

Continental U. S.

Quantity

Item

________ Inline cartridge @ $8.00 (U.S.) monthly

__________

________ Inline cartridge @ $48.00 (U.S.) prepay*

__________

TX Residents add 8.25% sales tax ($8.66 or $51.96)

Canada, Hawaii and Alaska

Quantity

Item

________ Inline cartridge @ $8.50 (U.S.) monthly

__________

________ Inline cartridge @ $51.00 (U.S.) prepay *

__________

Total __________

If you wish to prepay by check or money order, complete this form and return

with payment for each filter cartridge. New cartridge(s) will arrive pre-paid 6

months later with an invoice for the next 6 month cycle and a pre-paid envelope

to continue enrollment.

Please complete this form and return it to enroll in the Water 4 Life Program.

This is not a contract, you may cancel your membership at any time.

* Your card will be charged now for the cartridge(s) that will be shipped in 6

months. If you did not just purchase the filtration system, please enter the date it

was purchased or the last date the filters were replaced. We will send the filters 6

months from the date that you enter.

Amount