- ページ 2
浄水器 Aquasana AQ-7000のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Aquasana AQ-7000 2 ページ。 In-line refrigerator & fountain filtration system
Aquasana AQ-7000 にも： インストレーション・インストラクション (2 ページ)
ページを印刷する1
5
Turn off water supply to refrigerator
Turn on the incoming water supply and
flush the filter into a bucket. Run water for 2-3
2
minutes to flush out air. The initial surge of
Locate an easily accessible section of
water may be discolored due to carbon fines
refrigerator water supply tubing or supply line to
refrigerator from under-sink.
(See Figure 3).
FLOW
OUTLET TO
INLET FROM
REFRIGERATOR
SUPPLY LINE
3
If installing on the back of a
refrigerator; cut and remove a 11.5" section of
refrigerator water supply tubing. Use a tube cutter for
copper tubing and a utility knife for plastic tubing,
Make sure ends are square and free from nicks and
deep scratches.
(See Figure 1).
Correct
Incorrect
Figure 1
4
Referring to "Using Push-In Fittings"
section below, insert refrigerator water supply tubing
into inlet push-in fitting on filter(see Figure 2).
FLOW
6
Shut off water supply again. Referring
Figure 2
to "Using Push-In Fittings" section, insert water
supply tube from refrigerator into outlet fitting
(see Figure 4).
Using Push-In Fittings To Attach Tubing
7
Use plastic strap to secure filter to
Push tubing in as far as it will go. Tubing must be
back of refrigerator or undersink.
inserted past o-ring and hit backstop. Pull tube to
ensure it is secured.
8
Turn on water supply to refrigerator
and check for leaks.
BACKSTOP
To Release Tubing
Push in grey collet to release tubing. With collet
held, pull tubing straight out.
COLLET
Figure 4
FILTER REPLACEMENT
The contaminants or other substances removed or reduced by this water
filter are not necessarily in all user's water. Filter life varies depending on
local water conditions and the volume of water used. We recommend that
you change your filter every 6 months. However, it can be replaced earlier
if there is a drop in flow rate at the refrigerator's water dispenser (if pres-
ent) or if the icemaker's performance deteriorates.
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
FILTER REPLACEMENT INSTRUCTIONS
1. Turn off water supply to refrigerator.
2. Referring to section "Using Push-In Fitting", release tubing from both
ends of filter.
3. Referring to "Using Push-In Fittings" section, insert refrigerator water
supply tubing into inlet push-in fitting on filter.
4. Turn on the incoming water supply and flush the filter into a bucket.
Run water for 2-3 minutes to flush out air.
5. Shut off water supply again. Referring to "Using Push-In Fittings"
section, insert water supply tube from refrigerator into outlet fitting.
6. Turn on water supply to refrigerator and check for leaks.
TROUBLESHOOTING GUIDE
Water leaks at Push-in Connections: Push tubing in as far as it will go. If
leaking continues, shut off water at the original valve and remove water
line by pushing in on the connector collar while pulling the tubing away.
See, "Using Push-In Fitting" section. Inspect tubing for cracks and
scratches. If tubing is cracked or scratched, simply cut that portion away
Figure 3
and reinsert new end of tubing into fitting. Make sure tubing is cut straight.
If not, re-cut.
CONTACT
Contact customer service toll free in the U.S.A. And Canada
1-866-NO-BOTTLE(662-6885)
Monday through Friday 7:00 a.m to 7:00 p.m (CST) Saturday, 10:00
a.m. to 2 p.m (CST) or write us at:
Sun Water Systems
Customer Experience Center
6310 Midway Road
Haltom City, TX. 76117
Please include a daytime phone number in your correspondence.
FLOW
BEST SERVICE, BEST VALUE!
WATER 4 LIFE
®
AUTO-SHIP REPLACEMENT PROGRAM
Enroll Me Now!
Name______________________________________________________
Address____________________________________________________
____________________________________________________
City___________________ St/Prov____________ Zip_______________
Email______________________________________________________
Phone______________________________________________________
Credit Card Type________________ Expiration Date_____/_____/_____
Credit Card #________________________________________________
Signature_________________________________ Date______________
Date Purchased______/______/_________
Additional Shipping Charges apply for Canada, Hawaii, Alaska.
TX residents must pay an additional 8.25% sales tax.
Continental U. S.
Quantity
Item
________ Inline cartridge @ $8.00 (U.S.) monthly
__________
________ Inline cartridge @ $48.00 (U.S.) prepay*
__________
TX Residents add 8.25% sales tax ($8.66 or $51.96)
Canada, Hawaii and Alaska
Quantity
Item
________ Inline cartridge @ $8.50 (U.S.) monthly
__________
________ Inline cartridge @ $51.00 (U.S.) prepay *
__________
Total __________
If you wish to prepay by check or money order, complete this form and return
with payment for each filter cartridge. New cartridge(s) will arrive pre-paid 6
months later with an invoice for the next 6 month cycle and a pre-paid envelope
to continue enrollment.
Please complete this form and return it to enroll in the Water 4 Life Program.
This is not a contract, you may cancel your membership at any time.
* Your card will be charged now for the cartridge(s) that will be shipped in 6
months. If you did not just purchase the filtration system, please enter the date it
was purchased or the last date the filters were replaced. We will send the filters 6
months from the date that you enter.
Amount
Amount