HP StorageWorks XP10000 - Disk Array Manual del usuario - Página 21

c. Click OK to continue. The Multi Release window appears.

Figure 5

d. In the CU box, click the CU.

e. In the table, click more than one LDEV and then click Release. The Multi Release pane closes and

the new settings are shown in blue on the Cache LUN pane. To cancel operations, click Cancel. Go

step

To remove cache data for another CU:LDEV, repeat the previous steps.

If the deletions are correct, click Apply. A confirmation dialog box appears.

Click OK to confirm. The Cache LUN XP operation begins. If prestaging was selected, the prestaging

operation will occur next. When the operation has been completed, a confirmation dialog box

appears.

Click OK.

NOTE:

Response time might be slow if you try to delete cache-resident data. This causes a conflict

because host I/O occurs at the same time data is written to the disk drive (destaging). To avoid slow

response time, limit the amount of data you try to delete during one operation as follows:

•

When the host timeout period is set to 11 seconds or more

Open system: 3 GB or less

Mainframe system: 3,000 cylinders or less

•

When the host timeout period is set to 10 seconds or less

Open system: 1 GB or less

Mainframe system: 1,000 cylinders or less

Changing an extent's mode and pre-staging

You cannot directly change a cache extent's mode or pre-staging settings. You must delete the extent and

reconfigure it with new settings.

Select and release (remove) the extent in the Cache LUN XP cache.

Remake the extent with the new mode and pre-staging settings.

Cache LUN XP user guide for the XP10000/XP12000