HP Xw460c - ProLiant - Blade Workstation Manual de gestión - Página 11

Navegue en línea o descargue pdf Manual de gestión para Interruptor HP Xw460c - ProLiant - Blade Workstation. HP Xw460c - ProLiant - Blade Workstation 28 páginas. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
También para HP Xw460c - ProLiant - Blade Workstation: Manual de aplicación (35 páginas), Manual de prevención de errores (12 páginas), Libro Blanco técnico (12 páginas), Actualización del firmware (9 páginas), Manual de instalación (2 páginas), Manual de preguntas frecuentes (14 páginas), Póster de instalación (9 páginas), Manual de instalación (33 páginas), Manual de hardware (23 páginas), Visión general (35 páginas), Manual del usuario (33 páginas), Manual de optimización (13 páginas), Garantía limitada (10 páginas), Manual de instrucciones de instalación (10 páginas), Manual de instrucciones de instalación (8 páginas), Instrucciones de instalación (4 páginas), Instrucciones de instalación (2 páginas)

standby to increase overall enclosure power subsystem efficiency. When Dynamic Power Savings

mode is disabled, all power supplies share the load equally.

Enclosure bay IP addressing

The Onboard Administrator significantly enhances the management network infrastructure by offering

a single point from which to assign IP addresses to the server blade iLO 2 management ports and the

interconnect module management ports. By default, the Onboard Administrator, iLO 2, and supported

interconnect module management processors such as Virtual Connect Manager are configured to

acquire an IP address using Dynamic Host Configuration Protocol (DHCP) on the external

management network. For installations using static IP addressing, the Onboard Administrator offers

Enclosure Bay IP Addressing (EBIPA) as an alternative to manual configuration.

If EBIPA is enabled and the management ports are set to receive an IP address using DHCP, the IP

address settings can be managed by the Onboard Administrator using EBIPA. Using the autofill

feature, the administrator can input a range of IP addresses into the OA form (Figure 10). For

example, if the address of bay 1 is input as 12.240.62.11, autofill creates consecutively numbered IP

addresses for bays 2 through 16, starting with 12.240.62.12. IP addresses can be assigned to

unpopulated bays. Once a server or interconnect module is inserted into an EBIPA-enabled bay, it will

receive the pre-set IP address for that bay as well as the Shared Device Settings.

EBIPA settings are also present in the First Time Setup Wizard. There they provide the same

functionality; however, the wizard allows the address range to span multiple enclosures.

Figure 10. Onboard Administrator web GUI – Device Bay EBIPA settings