Panasonic PT-CW330 Folleto y especificaciones - Página 4
Navegue en línea o descargue pdf Folleto y especificaciones para Proyector Panasonic PT-CW330. Panasonic PT-CW330 4 páginas. Ultra short-throw dlp projectors
También para Panasonic PT-CW330: Especificaciones (6 páginas), Especificaciones (13 páginas)
Imprimir página
Specifi cations
Model
PT-CW330
Power supply
340 W (0.5 W when STANDBY MODE set to ECO,*
Power consumption
6.0 W when STANDBY MODE set to NORMAL.)
Panel size
DLP™
Display method
chip
Pixels
Lens
280 W UHM lamp (The lamp
Lamp
replacement cycle is 4,000 hours*
Screen size (diagonal)
1.78 – 2.54 m (70 – 100 inches) (16:10 aspect ratio)
Color reproducibility
Brightness*³
Center-to-corner uniformity*³
Contrast*³
Resolution
(Input signals that exceed this resolution will be converted to 1,280 × 800 pixels.)
HDMI
RGB (analog)
f
: 15.75 kHz, f
H
Scanning
f
: 31.50 kHz, f
H
frequency
YP
P
(YC
C
)
f
: 45.00 kHz, f
B
R
B
R
H
f
: 33.75 kHz, f
H
f
: 27.00 kHz, f
H
Video/S-Video
Keystone correction range
Installation
Built-in speaker
HDMI IN
COMPUTER IN 1
COMPUTER IN 2
MONITOR OUT
VIDEO IN
S-VIDEO IN
Terminals
COMPUTER AUDIO IN
VIDEO AUDIO IN
S-VIDEO AUDIO IN
AUDIO OUT
SERIAL IN
LAN
(RJ-45) × 1 (for network connection, 100BASE-TX/10BASE-T, compliant with PJLink™ (class 1))
Mini USB
Cabinet materials
Dimensions (W × H × D)
Weight
Approx.7.7 kg (17.0 lbs)*
37 dB (Lamp power: Normal);
Noise level
33 dB (Lamp power: Eco)
Operating environment
Supplied accessories
Power cord (3 m) x 1*
Optional accessories
Ceiling mount
Ceiling mount
bracket
bracket
for high ceilings*
6
for low ceilings*
ET-PKV100H
ET-PKV100S
Bracket assembly
ET-PKC200B
Caution
Do not install the projector in locations that are subject to excessive water, humidity, steam or oily smoke. Doing so may result in fi re, malfunction or electric shock.
NOTE ON USE
1 The projector uses a high-voltage mercury lamp under high internal pressure. This lamp may break, emitting a popping
sound, or fail to illuminate, due to impact or extended use.
2 The high-wattage lamp becomes very hot during operation. Please observe the following precautions:
• Never place objects on top of the projector while it is in operation.
• Make sure there is an unobstructed space of 500 mm (19-11/16 in) or more around the projector's exhaust openings.
• If stacking projector units, care must be taken to provide the recommended space between units. These space
requirements also apply to installation where only one projector unit is operating at one time and the other unit is used
as a backup.
Weights and dimensions shown are approximate. Specifi cations and appearance are subject to
change without notice. Product availability differs depending on region and country.
This product may be subject to export control regulations.
The projection distances and throw ratios given in this brochure are for use only as guidelines.
For more detailed information, please consult the dealer from whom you are purchasing the product.
The PJLink trademark is an application trademark in Japan, the United States, and other countries
and regions or registered trademarks. DLP™ (Digital Light Processing), DLP™ Chip, DLP Medallion
Logo and DLP
TM
Link™ are trademarks or registered trademarks of Texas Instruments.
HDMI, the HDMI logo and High-Defi nition Multimedia Interface is a trademark or registered trademark of
HDMI Licensing LLC. Crestron and RoomView are registered trademarks of Crestron Electronics, Inc.
All other trademarks are the property of their respective trademark owners. Projection images simulated.
© 2013 Panasonic Corporation. All rights reserved.
PT-CW240
100 – 240 V AC, 50/60 Hz
1
310 W (0.5 W when STANDBY MODE set to ECO,*
6.0 W when STANDBY MODE set to NORMAL.)
16.5 mm (0.65 inches) (16:10 aspect ratio)
DLP™ chip x 1
1,024,000 (1,280 x 800) pixels
Fixed/manual focus F = 2.6 f = –5.27 mm
240 W UHM lamp (The lamp
2
)
replacement cycle is 5,000 hours*
Full color (16.77 million colors)
3100 lm
2600 lm
80%
8000:1 (full on/off)(During RGB signal input, Lamp power:Normal)
1,280 × 800 pixels
(Horizontal) 15–100 kHz; (Vertical) 24–120 Hz; (Dot clock) 25-162 MHz
(Horizontal) 15–100 kHz; (Vertical) 24–120 Hz; (Dot clock) 162 MHz or lower
: 60 Hz [480i(525i)]
f
: 15.63 kHz, f
: 50 Hz [576i(625i)]
V
H
V
f
: 31.25 kHz, f
: 50 Hz [576p(625p)]
: 60 Hz [480p(525p)]
V
H
V
: 60 Hz [720(750)/60p]
f
: 37.50 kHz, f
: 50 Hz [720(750)/50p]
H
V
V
: 60 Hz [1080(1125)/60i]
f
: 28.13 kHz, f
: 50 Hz [1080(1125)/50i]
V
H
V
: 24 Hz [1080(1125)/24p]
f
: 67.50 kHz, f
: 60 Hz [1080(1125)/60p] f
V
H
V
(fH) 15.75/15.63 kHz (fV) 50/60 Hz [NTSC/NTSC4.43/PAL/PAL60/PAL-N/PAL-M/SECAM]
Vertical: ± 15°
Ceiling/fl oor, front/rear (Menu setting)
7 cm x 3 cm Oval x1 output power 10 W (Monaural)
(HDMI 19-pin) x 1 (Deep color, compatible with HDCP)
Audio signal Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)
D-sub HD 15-pin (female) x 1 [RGB/YP
D-sub HD 15-pin (female) x 1 [RGB/YP
D-sub HD 15-pin (female) x 1 (The signal selected from computer input 1/2 is output.)
Pin jack × 1
Mini DIN 4-pin × 1
M3 x 2 (L-R x 1)
Pin jack x 2 (L-R x 1)
Pin jack x 2 (L-R x 1)
M3 x 1 (L-R x 1)
D-sub 9-pin (female) × 1 for external control (RS-232C compliant)
1 for servicemen
Molded plastic (PC)
357 x 250 x 367 mm (14-1/16" × 9-27/32" × 14-29/64") (with legs at shortest position)
4
Approx.7.5 kg (16.5 lbs)*
35 dB (Lamp power: Normal);
30 dB (Lamp power: Eco)
Operating temperature: 5° – 40°C(41° – 104°F) (Less than 762 m above sea level);
5° – 35°C(41° – 95°F) (762 – 1524 m above sea level)
5° – 30°C(41° – 86°F) (1524 – 3048 m above sea level)
Operating humidity: 20% - 80% (no condensation)
5
, Power cord cover x 1, Wireless remote control unit x 1, Lithium coin cell battery x 1, Computer cable (1.8 m) x 1
Wall mount bracket
ET-PKC200W
6
PT-CX300
1
340 W (0.5 W when STANDBY MODE set to ECO,*
6.0 W when STANDBY MODE set to NORMAL.)
14 mm (0.55 inches) (4:3 aspect ratio)
DLP™ system
786,432 (1,024 x 768) pixels
280 W UHM lamp (The lamp
2
)
replacement cycle is 4,000 hours*
1.52 – 2.29 m (60 - 90 inch) (4:3 aspect ratio)
3100 lm
1,024 × 768 pixels (Input signals that exceed this
resolution will be converted to 1,024 × 768 pixels.)
: 56.25 kHz, f
: 50 Hz [1080(1125)/50p]
H
V
(C
)/P
(C
) x 1]
B
B
R
R
(C
)/P
(C
) x 1]
B
B
R
R
4
Approx.7.7 kg (17.0 lbs)*
37 dB (Lamp power: Normal);
33 dB (Lamp power: Eco)
Replacement
lamp unit
ET-LAC300
*Exclusively for
PT-CW330/CX300
Replacement
lamp unit
ET-LAC200
*Exclusively for
PT-CW240
• If the projector is placed in a box or enclosure, the temperature of the air surrounding the projector must match the
operating temperature listed in the specifi cations table during use. Also, make sure the projector's intake and exhaust
openings are not blocked. Ensure there is suffi cient ventilation to prevent hot air from the exhaust openings being
recirculated into the intake opening.
3 The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods.
• The lamp replacement cycle varies greatly depending on individual lamp characteristics and usage conditions.
• The brightness of the lamp will gradually decrease with use.
4 Due to natural characteristics of lamps, screen brightness may fl uctuate. This is not an indication of faulty lamp performance.
Projection distance
1
2
)
Projected image
PT-CW330/CW240 (16:10 aspect ratio; throw ratio: 0.35:1)
Distance from
Distance from
the edge of
Diagonal
the projector
the projection
image size
front to the
window to the
screen (B)
screen (A)
(1.71') 0.18 (0.59')
1.78
[70"]
0.52
(1.97') 0.26 (0.85')
2.03
[80"]
0.60
(2.23') 0.34 (1.12') 0.23 (0.75') 0.30 (0.98')
2.29
[90"]
0.68
(2.49')
2.54
[100"]
0.76
0.42
PT-CX300 (4:3 aspect ratio; throw ratio: 0.44:1)
Distance from
Distance from
the edge of
Diagonal
the projector
the projection
image size
front to the
window to the
screen (B)
screen (A)
(1.71') 0.19 (0.62')
1.52
[60"]
0.52
(2.00') 0.28 (0.92')
1.78
[70"]
0.62
(2.33') 0.38 (1.25') 0.27 (0.89') 0.34 (1.12')
2.03
[80"]
0.71
(2.62')
2.29
[90"]
0.80
0.47
Dimensions
4
357(14-1/16)
*1 When [LAN (Standby)]/[VGA Out (Standby)]/[In Standby
Mode (Audio)] are all set to [Off].
*2 This is the maximum value when the lamp power is set to
Eco mode where the lamp is turned on for 2 hours and off
for 0.25 hours. If the lamp is turned on more times or kept
on for a long time, the lamp replacement cycle will shorten.
In Normal mode, the lamp replacement cycle is 3,000 hours.
The usage environment affects the duration of the lamp.
*3 Measurement, measuring conditions, and method of
notation all comply with ISO 21118 international standards.
*4 The above values are averages. Actual values may be
different according to the product.
*5 Power code (x2) for the PT-CW330EA/CW240EA/CX300EA
*6 This product is used together with an optional bracket
assembly (sold separately).
For more information about Panasonic projectors, please visit
Projector Global Web Site – panasonic.net/avc/projector
Facebook – www.facebook.com/panasonicprojector
YouTube – www.youtube.com/user/PanasonicProjector
All information included here is valid as of January 2013.
PT-CW330G1 Printed in Japan.
unit: meters (feet)
Height from
Height from
the edge of
the edge of the
the screen to
screen to the
the top of the
bottom of the
projector (E)
projector (F)
(0.52')
(0.79')
0.16
0.24
(0.62')
(0.89')
0.19
0.27
(1.38')
(0.85')
(1.12')
0.26
0.34
Height from
Height from
the edge of
the edge of the
the screen to
screen to the
the top of the
bottom of the
projector (E)
projector (F)
(0.59')
(0.85')
0.18
0.26
(0.75')
(0.98')
0.23
0.30
(1.54')
(1.02')
(1.28')
0.31
0.39
unit: mm (inch)
367(14-29/64)