Panasonic PT-CW330 브로셔 및 사양 - 페이지 4

{카테고리_이름} Panasonic PT-CW330에 대한 브로셔 및 사양을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-CW330 4 페이지. Ultra short-throw dlp projectors
Panasonic PT-CW330에 대해서도 마찬가지입니다: 사양 (6 페이지), 사양 (13 페이지)

페이지 인쇄

Speciﬁ cations

Model

PT-CW330

Power supply

340 W (0.5 W when STANDBY MODE set to ECO,*

Power consumption

6.0 W when STANDBY MODE set to NORMAL.)

Panel size

DLP™

Display method

chip

Pixels

Lens

280 W UHM lamp (The lamp

Lamp

replacement cycle is 4,000 hours*

Screen size (diagonal)

1.78 – 2.54 m (70 – 100 inches) (16:10 aspect ratio)

Color reproducibility

Brightness*³

Center-to-corner uniformity*³

Contrast*³

Resolution

(Input signals that exceed this resolution will be converted to 1,280 × 800 pixels.)

HDMI

RGB (analog)

: 15.75 kHz, f

Scanning

: 31.50 kHz, f

frequency

(YC

)

: 45.00 kHz, f

: 33.75 kHz, f

: 27.00 kHz, f

Video/S-Video

Keystone correction range

Installation

Built-in speaker

HDMI IN

COMPUTER IN 1

COMPUTER IN 2

MONITOR OUT

VIDEO IN

S-VIDEO IN

Terminals

COMPUTER AUDIO IN

VIDEO AUDIO IN

S-VIDEO AUDIO IN

AUDIO OUT

SERIAL IN

LAN

(RJ-45) × 1 (for network connection, 100BASE-TX/10BASE-T, compliant with PJLink™ (class 1))

Mini USB

Cabinet materials

Dimensions (W × H × D)

Weight

Approx.7.7 kg (17.0 lbs)*

37 dB (Lamp power: Normal);

Noise level

33 dB (Lamp power: Eco)

Operating environment

Supplied accessories

Power cord (3 m) x 1*

Optional accessories

Ceiling mount

bracket

for high ceilings*

for low ceilings*

ET-PKV100H

ET-PKV100S

Bracket assembly

ET-PKC200B

Caution

Do not install the projector in locations that are subject to excessive water, humidity, steam or oily smoke. Doing so may result in ﬁ re, malfunction or electric shock.

NOTE ON USE

1 The projector uses a high-voltage mercury lamp under high internal pressure. This lamp may break, emitting a popping

sound, or fail to illuminate, due to impact or extended use.

2 The high-wattage lamp becomes very hot during operation. Please observe the following precautions:

• Never place objects on top of the projector while it is in operation.

• Make sure there is an unobstructed space of 500 mm (19-11/16 in) or more around the projector's exhaust openings.

• If stacking projector units, care must be taken to provide the recommended space between units. These space

requirements also apply to installation where only one projector unit is operating at one time and the other unit is used

as a backup.

Weights and dimensions shown are approximate. Speciﬁ cations and appearance are subject to

change without notice. Product availability differs depending on region and country.

This product may be subject to export control regulations.

The projection distances and throw ratios given in this brochure are for use only as guidelines.

For more detailed information, please consult the dealer from whom you are purchasing the product.

The PJLink trademark is an application trademark in Japan, the United States, and other countries

and regions or registered trademarks. DLP™ (Digital Light Processing), DLP™ Chip, DLP Medallion

Logo and DLP

Link™ are trademarks or registered trademarks of Texas Instruments.

HDMI, the HDMI logo and High-Deﬁ nition Multimedia Interface is a trademark or registered trademark of

HDMI Licensing LLC. Crestron and RoomView are registered trademarks of Crestron Electronics, Inc.

All other trademarks are the property of their respective trademark owners. Projection images simulated.

PT-CW240

100 – 240 V AC, 50/60 Hz

310 W (0.5 W when STANDBY MODE set to ECO,*

6.0 W when STANDBY MODE set to NORMAL.)

16.5 mm (0.65 inches) (16:10 aspect ratio)

DLP™ chip x 1

1,024,000 (1,280 x 800) pixels

Fixed/manual focus F = 2.6 f = –5.27 mm

240 W UHM lamp (The lamp

)

replacement cycle is 5,000 hours*

Full color (16.77 million colors)

3100 lm

2600 lm

80%

8000:1 (full on/off)(During RGB signal input, Lamp power:Normal)

1,280 × 800 pixels

(Horizontal) 15–100 kHz; (Vertical) 24–120 Hz; (Dot clock) 25-162 MHz

(Horizontal) 15–100 kHz; (Vertical) 24–120 Hz; (Dot clock) 162 MHz or lower

: 60 Hz [480i(525i)]

: 15.63 kHz, f

: 50 Hz [576i(625i)]

: 31.25 kHz, f

: 50 Hz [576p(625p)]

: 60 Hz [480p(525p)]

: 60 Hz [720(750)/60p]

: 37.50 kHz, f

: 50 Hz [720(750)/50p]

: 60 Hz [1080(1125)/60i]

: 28.13 kHz, f

: 50 Hz [1080(1125)/50i]

: 24 Hz [1080(1125)/24p]

: 67.50 kHz, f

: 60 Hz [1080(1125)/60p] f

(fH) 15.75/15.63 kHz (fV) 50/60 Hz [NTSC/NTSC4.43/PAL/PAL60/PAL-N/PAL-M/SECAM]

Vertical: ± 15°

Ceiling/ﬂ oor, front/rear (Menu setting)

7 cm x 3 cm Oval x1 output power 10 W (Monaural)

(HDMI 19-pin) x 1 (Deep color, compatible with HDCP)

Audio signal Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)

D-sub HD 15-pin (female) x 1 [RGB/YP

D-sub HD 15-pin (female) x 1 (The signal selected from computer input 1/2 is output.)

Pin jack × 1

Mini DIN 4-pin × 1

M3 x 2 (L-R x 1)

Pin jack x 2 (L-R x 1)

M3 x 1 (L-R x 1)

D-sub 9-pin (female) × 1 for external control (RS-232C compliant)

1 for servicemen

Molded plastic (PC)

357 x 250 x 367 mm (14-1/16" × 9-27/32" × 14-29/64") (with legs at shortest position)

Approx.7.5 kg (16.5 lbs)*

35 dB (Lamp power: Normal);

30 dB (Lamp power: Eco)

Operating temperature: 5° – 40°C(41° – 104°F) (Less than 762 m above sea level);

5° – 35°C(41° – 95°F) (762 – 1524 m above sea level)

5° – 30°C(41° – 86°F) (1524 – 3048 m above sea level)

Operating humidity: 20% - 80% (no condensation)

, Power cord cover x 1, Wireless remote control unit x 1, Lithium coin cell battery x 1, Computer cable (1.8 m) x 1

Wall mount bracket

ET-PKC200W

PT-CX300

340 W (0.5 W when STANDBY MODE set to ECO,*

6.0 W when STANDBY MODE set to NORMAL.)

14 mm (0.55 inches) (4:3 aspect ratio)

DLP™ system

786,432 (1,024 x 768) pixels

280 W UHM lamp (The lamp

)

replacement cycle is 4,000 hours*

1.52 – 2.29 m (60 - 90 inch) (4:3 aspect ratio)

3100 lm

1,024 × 768 pixels (Input signals that exceed this

resolution will be converted to 1,024 × 768 pixels.)

: 56.25 kHz, f

: 50 Hz [1080(1125)/50p]

)/P

) x 1]

)/P

) x 1]

Approx.7.7 kg (17.0 lbs)*

37 dB (Lamp power: Normal);

33 dB (Lamp power: Eco)

Replacement

lamp unit

ET-LAC300

*Exclusively for

PT-CW330/CX300

Replacement

lamp unit

ET-LAC200

*Exclusively for

PT-CW240

• If the projector is placed in a box or enclosure, the temperature of the air surrounding the projector must match the

operating temperature listed in the speciﬁ cations table during use. Also, make sure the projector's intake and exhaust

openings are not blocked. Ensure there is sufﬁ cient ventilation to prevent hot air from the exhaust openings being

recirculated into the intake opening.

3 The lamp replacement cycle duration becomes shorter if the projector is operated repeatedly for short periods.

• The lamp replacement cycle varies greatly depending on individual lamp characteristics and usage conditions.

• The brightness of the lamp will gradually decrease with use.

4 Due to natural characteristics of lamps, screen brightness may ﬂ uctuate. This is not an indication of faulty lamp performance.

Projection distance

)

Projected image

PT-CW330/CW240 (16:10 aspect ratio; throw ratio: 0.35:1)

Distance from

the edge of

Diagonal

the projector

the projection

image size

front to the

window to the

screen (B)

screen (A)

(1.71') 0.18 (0.59')

1.78

[70"]

0.52

(1.97') 0.26 (0.85')

2.03

[80"]

0.60

(2.23') 0.34 (1.12') 0.23 (0.75') 0.30 (0.98')

2.29

[90"]

0.68

(2.49')

2.54

[100"]

0.76

0.42

PT-CX300 (4:3 aspect ratio; throw ratio: 0.44:1)

Distance from

the edge of

Diagonal

the projector

the projection

image size

front to the

window to the

screen (B)

screen (A)

(1.71') 0.19 (0.62')

1.52

[60"]

0.52

(2.00') 0.28 (0.92')

1.78

[70"]

0.62

(2.33') 0.38 (1.25') 0.27 (0.89') 0.34 (1.12')

2.03

[80"]

0.71

(2.62')

2.29

[90"]

0.80

0.47

Dimensions

357(14-1/16)

*1 When [LAN (Standby)]/[VGA Out (Standby)]/[In Standby

Mode (Audio)] are all set to [Off].

*2 This is the maximum value when the lamp power is set to

Eco mode where the lamp is turned on for 2 hours and off

for 0.25 hours. If the lamp is turned on more times or kept

on for a long time, the lamp replacement cycle will shorten.

In Normal mode, the lamp replacement cycle is 3,000 hours.

The usage environment affects the duration of the lamp.

*3 Measurement, measuring conditions, and method of

notation all comply with ISO 21118 international standards.

*4 The above values are averages. Actual values may be

different according to the product.

*5 Power code (x2) for the PT-CW330EA/CW240EA/CX300EA

*6 This product is used together with an optional bracket

assembly (sold separately).

For more information about Panasonic projectors, please visit

Projector Global Web Site – panasonic.net/avc/projector

Facebook – www.facebook.com/panasonicprojector

YouTube – www.youtube.com/user/PanasonicProjector

All information included here is valid as of January 2013.

PT-CW330G1 Printed in Japan.

unit: meters (feet)

Height from

the edge of

the edge of the

the screen to

screen to the

the top of the

bottom of the

projector (E)

projector (F)

(0.52')

(0.79')

0.16

0.24

(0.62')

(0.89')

0.19

0.27

(1.38')

(0.85')

(1.12')

0.26

0.34

Height from

the edge of

the edge of the

the screen to

screen to the

the top of the

bottom of the

projector (E)

projector (F)

(0.59')

(0.85')

0.18

0.26

(0.75')

(0.98')

0.23

0.30

(1.54')

(1.02')

(1.28')

0.31

0.39

unit: mm (inch)

367(14-29/64)