Diamond Traffic Products TTC-4420 Manual - Página 13

Navegue en línea o descargue pdf Manual para Caja Diamond Traffic Products TTC-4420. Diamond Traffic Products TTC-4420 14 páginas. Trail counter

After the display has become active

touch

the magnet to the red dot to continue

the

data deletion process. The display should read:

Next, to reaffirm you wish to delete memory

again, touch the yellow dot (that activates the

display) to reset the counter. While

the counter is clearing the memory

the display will read:

Note: If the siren sounds, the counter is not aligned with the reflector

and needs to be adjusted. See page 10.

When the counter has captured the return beam from the reflector, the

signal will stop and the counter will enter test mode to verify

the reflector is aligned with the counter and at what percent the signal

strength is. We recommend that you

achieve a signal strength of 80% or

better for optimal results. The counter

will also collect "test counts" when

the beam is broken for verification that the unit is working. You must

block the beam for about 1/6 of a second or more. Easiest method is for

someone to walk in between the counter and the reflector. The display

should read as above:

Once the counter is aligned and securely fastened to a tree, post or

alternate mounting device, and you are ready to start your data

collection cycle touch the magnet to the yellow dot. Now your new data

collection cycle has begun. Remember to log the time and date as the

counter does not record this information.

Note: The counter will eventually enter sleep mode, signified by the

display going blank, to conserve battery life. This should occur in

approximately 10-15 minutes after collection cycle has begun.

P12

ACTIVATE DISPLAY TO

CLEAR MEMORY

CLEARING MEMORY

AND STARTING NEW

BEAM ALIGN: xx%

TEST COUNT: ___