Diamond Traffic Products TTC-4420 Podręcznik - Strona 13
Przeglądaj online lub pobierz pdf Podręcznik dla Licznik gotówki Diamond Traffic Products TTC-4420. Diamond Traffic Products TTC-4420 14 stron. Trail counter
Drukuj stronęAfter the display has become active
touch
the magnet to the red dot to continue
the
data deletion process. The display should read:
Next, to reaffirm you wish to delete memory
again, touch the yellow dot (that activates the
display) to reset the counter. While
the counter is clearing the memory
the display will read:
Note: If the siren sounds, the counter is not aligned with the reflector
and needs to be adjusted. See page 10.
When the counter has captured the return beam from the reflector, the
signal will stop and the counter will enter test mode to verify
the reflector is aligned with the counter and at what percent the signal
strength is. We recommend that you
achieve a signal strength of 80% or
better for optimal results. The counter
will also collect "test counts" when
the beam is broken for verification that the unit is working. You must
block the beam for about 1/6 of a second or more. Easiest method is for
someone to walk in between the counter and the reflector. The display
should read as above:
Once the counter is aligned and securely fastened to a tree, post or
alternate mounting device, and you are ready to start your data
collection cycle touch the magnet to the yellow dot. Now your new data
collection cycle has begun. Remember to log the time and date as the
counter does not record this information.
Note: The counter will eventually enter sleep mode, signified by the
display going blank, to conserve battery life. This should occur in
approximately 10-15 minutes after collection cycle has begun.
P12
ACTIVATE DISPLAY TO
CLEAR MEMORY
CLEARING MEMORY
AND STARTING NEW
BEAM ALIGN: xx%
TEST COUNT: ___