Epever SHI3000 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Inversor Epever SHI3000. Epever SHI3000 20 páginas. Shi series pure sine wave inverter

3. Inverter Operation

Connect the input and output terminals accurately. Turn on the

power using the ON / OFF switch on the front panel. In order to

avoid the protections resulted from the surge power, please turn on

AC loads one by one after the output of the inverter is normal.

Please check it as below:

 Set the power switch to the „OFF‟ position. Insert the load‟s plug

into the inverter‟s output outlet.

 Connect the protective grounding to the ground.

 Make sure the fuse or breaker use between battery and inverter

is off.

 Connect the battery („+‟ terminal with red line, „-‟with black line).

Do not connect them by contraries, or the power inverter will be

damaged.

 Switch on the fuse or breaker. Switch the inverter to ON and then

turn on the loads one by one. Check the operation state of both

power inverter and loads. „Green‟ of the failure LED indicator

means the state is normal.

 If there are different loads, it is suggested that turn on the load

with large startup current first, such as television, then turn on the

load such as lamp when the inverter works stable.

 If the failure LED indicator is „Red‟ and the buzzer alarms or no

output when you turn on devices, switch off the loads and

power inverter immediately. Check the system by referring to the

troubleshooting guide. Turn on the devices again according to

the operation methods after the failure is removed.