DieHard 200.71224 Manual del usuario - Página 10
Navegue en línea o descargue pdf Manual del usuario para Cargador de batería DieHard 200.71224. DieHard 200.71224 17 páginas. Battery charger 15/2 amp fully automatic microprocessor controlled engine starter 100 amp
También para DieHard 200.71224: Manual del usuario (16 páginas)
Imprimir página
IMPORTANT:
Follow all safety instruc-
tions and precautions when charging
your battery. Wear complete eye
protection and clothing protection.
Charge your battery in a well-ventilated
area.
Charging
your battery
in the vehicle:
1. Avoid
personal
injury
by keeping
clear of fan blades, belts, pulleys and
other engine parts.
2. Avoid damaging the charger by
keeping the power cord and output
cords away from the hood, door or
moving engine parts.
3. Note the polarity of the battery
posts
by checking
the identification
marks
on the battery:
POSITIVE
(POS,
P or
+) and NEGATIVE
(NEG,
N or -). The
positive
post is usually
larger
than
the negative
post.
4. Identify
which
battery
post is
grounded
or connected
to the
chassis.
THIS
IS NORMALLY
THE
NEGATIVE
POST.
NEGATIVE
GROUNDED
SYSTEM
5. Connecting
to a negative-
grounded
system:
Connect
the red
(POSITIVE)
output
clamp to the
POSITIVE
post of the battery. Rock
and twist the clamp back and forth to
be sure a solid electrical connection
.
.
is made. Then connect the black
(NEGATIVE)
output clamp to a
heavy, unpainted metal part of the
chassis or engine block, away from
the battery (see figure above). DO
NOT connect clamp to negative
battery post, carburetor, fuel line or
sheet metal part.
Connecting
to a positive-grounded
system:
Connect
the black (NEGA-
TIVE) output clamp to the NEGA-
TIVE post of the battery. Rock and
twist the clamp back and forth to be
sure a solid electrical
connection
is
made. Then connect the red (POSI-
TIVE)
output clamp to a heavy,
unpainted
metal part of the chassis
or engine block, away from the
battery.
DO NOT connect clamp to
positive battery post, carburetor,
fuel
line or sheet metal part.
Plug power
cord into an AC outlet.
The charger
will set to the default
state of 2 AMP charge
rate and Type
1 for battery
type.
Press the appropriate control buttons
to select the desired charge rate and
battery type. Within a few- seconds,
the red LED should go out and the
charging process should start. If the
red LED does not go out, check for
correct cable connection.
.
.
To disconnect
the charger,
unplug
the charger
power cord before
attempting
to disconnect
the output
clamps.
Then,
standing
away from
the battery,
remove
the output clamp
from the chassis
or engine
block.
Finally,
remove
the output
clamp
from the battery
post.
Clean and store the charger in a dry
location.
10