DieHard 200.71224 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Cargador de batería DieHard 200.71224. DieHard 200.71224 17 páginas. Battery charger 15/2 amp fully automatic microprocessor controlled engine starter 100 amp
También para DieHard 200.71224: Manual del usuario (16 páginas)

Imprimir página

With the exception

of AGM and gel cell

batteries,

all other

battery

types may or

may not have vent caps.

Vent caps are

located

on top of the battery

and provide

a means

to add distilled

water when

needed.

Batteries

should

be marked

with their type.

If charging

a battery

that

is not marked,

check

the manual

of the

item that uses the battery.

If the battery

type is unknown,

use the Type

position.

Make sure the battery

complies

with the safety

instructions

on page 3.

Engine cranking: When the 100A

Start rate is selected, the charger waits

until the engine is actually being

cranked before delivering 100 amps for

engine start. Note: The charger

delivers a charge of 3 to 7 amps while

waiting for the engine to be cranked and

will reset if the engine is not cranked

within 15 minutes. Cranking is allowed

for up to 3 seconds, then the charger

shuts down for a 4 minute cool down

period. During the cool down period the

Start LED will blink. After 4 minutes, the

Start LED will light continuously,

indicating that another crank cycle can

be performed.

Battery Status LEDs: The status of the

battery is indicated by a row of six

LED's. The first LED is red; it will light

under the following conditions:

1. The charger

is not connected

to a bat-

tery. Red LED lights continuously.

2. The charger is reverse-connected

to a

battery. Red LED lights continuously.

3. The charge

cycle

was not completed

within 24 hours.

Red LED blinks.

4. The battery

could

not be charged

in a

normal

manner.

This could be due to a

battery

with a partially

shorted

or open

cell, sulfated

battery

plates

or electro-

lyte out of balance.

Red LED blinks.

The next four LED's are amber. First,

only the leftmost amber LED will light.

Then two, then three, and eventually all

four amber LED's will light. Refer to

"Estimating Charge Time" on page 12

for more information.

The sixth LED is green and lights to indi-

cate that charging

is complete.

When the

green LED lights, the amber LED's will turn

off and the charger

starts Maintain

Mode.

See the Control Panel table on the next

page.

Setup and Operating: Follow all safety

and connecting procedures in this

manual. Located above each button on

the control pad is an amber LED that

lights to indicate that the selection is

active.

When first plugged in, the charger will

automatically

default to the 2 AMP /

TYPE 1 position. You may then select

the charge rate and battery type. For

example, if you're charging a large 12-

volt deep cycle battery, press the

buttons labeled 15 AMP and TYPE 2.

Note: If you press a charge rate or

battery type button after charging has

started, the charger will restart the

charging process. Refer to "Estimating

Charge Time" on page 12 for more

information.

When selecting the Start position, you

do not have to select a battery type. All

indicator lights will turn off except for the

light above the Start button. The red

LED will also light if a properly con-

nected battery has not been detected.