DieHard 200.71225 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Cargador de batería DieHard 200.71225. DieHard 200.71225 20 páginas. Microprocessor controlled, fully automatic operation battery charger with engine starter plus battery and alternator tester for 6 and 12-volt batteries
También para DieHard 200.71225: Manual del usuario (17 páginas)

Imprimir página

BATTERY CHARgINg - AC CONNECTIONS

8.1

For all grounded cord-connected battery chargers with an input rat-

ing less than 15 amperes and intended for use on a nominal 120-volt

circuit:

•

This battery charger is for use on a nominal 120-volt circuit, and has a

grounding plug that looks like the plug illustrated in sketch A in Figure

8.3. A temporary adapter, which looks like the adapter illustrated in

sketches B and C, may be used to connect this plug to a two-pole recep-

tacle as shown in sketch B if a properly grounded outlet is not available.

The temporary adapter should be used only until a properly grounded

outlet can be installed by a qualified electrician.

dANgER – Before using adapter as illustrated, be certain that center

screw of outlet plate is grounded. The green-colored rigid ear or lug ex

tending from adapter must be connected to a properly grounded outlet–

make certain it is grounded. If necessary, replace original outlet cover

plate screw with a longer screw that will secure adapter ear or lug to

outlet cover plate and make ground connection to grounded outlet.

•