EPHESUS Arena 650 Manual de instrucciones de instalación - Página 11

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipo para DJ EPHESUS Arena 650. EPHESUS Arena 650 16 páginas. All field led luminaire

Minimum tilt angles:
The side set screws will not allow the All Field to be tilted downward at an angle of less than 30° relative to vertical. If
fixture must be tilted between 20-30°, remove the side set screws.
If the fixture must be aimed at less than 20° tilt, use the inverted mounting configuration.
If a luminaire is installed downward at low angles in a warm or hot environment, the luminaire lumen output may
N
otee:
decrease to compensate for decreased heat dispersion ability.
If aiming by Orient-Tilt, use an inclinometer and protractor or similar tools to set the luminaires to the correct angles and skip
to Final Aiming.
Equipment Required:
Laser or Aiming Tube
Aiming Mount
15/16" (or metric equivalent) Socket Wrench
3/16" (or metric equivalent) Hex driver
Torque wrench/driver
NEVER use any power tools on the fixture while the power is on. The vibration caused by power tools may damage
the fixture. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND FAILURE.
N
otee:
For outdoor daytime aiming when the laser dot is difficult to see, a piece of rigid tubing may be used in place of the
laser. Outside diameter of tube must be 0.8"- 0.87" (ANSI NPS ½"; 20-22 mm) to fit into the Aiming Mount. Slightly
smaller conduit such as ½" (16 Metric) EMT (Electrical Metallic Tubing) may be used in the mount with a grommet
or other shim only if the shim is evenly distributed around the tubing to keep it correctly aligned parallel with the top
front visor of the luminaire.
NEVER point the aiming laser at any person or animal as it can cause permanent damage to eyes. Use laser only for
aiming fixtures as directed. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO SEVERE INJURY.
N
otee:
Turn off laser while not in use to conserve battery. Have spare battery charged to facilitate the aiming process.
WARNING
WARNING
Laser
Mount
Figure 9.
Aiming Laser & Mount
Installation Instructions - All Field LED Luminaire
EATON
MN507001EN
All Field Installation Manual rev 20170324
11