EPHESUS Stadium Manual de instrucciones de instalación - Página 11

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipo para DJ EPHESUS Stadium. EPHESUS Stadium 16 páginas. Stadium series

Imprimir página

Minimum tilt angles:

The side set screws will not allow the Stadium to be tilted downward at an angle of more than 60° relative to the horizontal

axis. If the fixture must be tilted down at an angle greater than 600 from the horizontal, remove the side set screws.

If the fixture must be aimed down at less than 20° tilt relative to the vertical axis, use the inverted mounting configuration.

If a luminaire is installed inverted at low angles in a warm or hot environment, the luminaire lumen output may

otee:

decrease to compensate for decreased heat dispersion ability.

If aiming by Orient-Tilt, use an inclinometer and protractor or similar tools to set the luminaires to the correct angles and skip

to Final Aiming.

Laser Mount Aiming

Equipment Required:

Laser or Aiming Tube

●

Aiming Mount

●

5/16" Socket Wrench or impact driver

●

3/16" Hex driver

●

Torque wrench/driver

●

1/8" Hex driver (for laser set screws, if needed)

●

NEVER use any power tools on the fixture while the power is on. The vibration caused by power tools may damage

the fixture. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND FAILURE.

otee:

For outdoor daytime aiming when the laser dot is difficult to see, a piece of rigid tubing may be used in place of the

laser. Outside diameter of tube must be 0.8"-0.87" (ANSI NPS 1/2") to fit into the Aiming Mount. Slightly smaller

conduit such as 1/2" EMT may be used in the mount with a grommet or other shim only if the shim is evenly

distributed around the tubing to keep it correctly aligned parallel with the top front visor of the luminaire.

NEVER point the aiming laser at any person or animal as it can cause permanent damage to eyes. Use laser only for

aiming fixtures as directed. FAILURE TO FOLLOW THIS WARNING MAY LEAD TO SEVERE INJURY.

otee:

Turn off laser while not in use to conserve battery. Have spare battery charged to facilitate the aiming process.

Make sure the laser pointer is secured within the mounting apparatus. Tighten to 10 in-lb with a 1/8" hex driver if

necessary.

Align the 'A' (cut into apparatus) side of the mounting apparatus parallel and front facing to the LED arrays.

Insert the aiming mount onto the center heat sink fin until it is fully seated. Aiming mount must be tight against the

fixture because any movement or wiggle in the mount will cause aiming to be inaccurate. Make sure it is seated on the

intersection of the center fins.

Installation Instructions - Stadium Series

WARNING

EATON

IB528002EN

Installation instructions rev 20171011