Olympus BH2 Series Desmontaje, limpieza y montaje - Página 16

Navegue en línea o descargue pdf Desmontaje, limpieza y montaje para Microscopio Olympus BH2 Series. Olympus BH2 Series 45 páginas. Phase contrast
También para Olympus BH2 Series: Manual de solución de problemas y ajuste (46 páginas), Desmontaje, limpieza y montaje completos (23 páginas), Desmontaje, limpieza y montaje completos (40 páginas), Manual (6 páginas), Manual de instalación (9 páginas)

Unscrew and remove the viewing head locking

thumbscrew from the tapped hole in the BHSU/BHTU

pillar arm (see

Figure

39).

Figure 39 – Unscrew and remove the locking thumbscrew

Clean the Locking Screw (BHSU/BHTU)

Use an acid brush and a suitable solvent to clean any

grease or contaminants from the threads of the locking

thumbscrew (see

Figure

Figure 40 – Clean the threads of the locking thumbscrew

Use a cotton swab and a suitable solvent (acetone) to

clean any grease or contaminants from the threads of

the tapped hole in the pillar arm (see

Figure 41 – Clean the threads of the tapped hole

Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames

40).

Figure

41).

Apply a light coating of grease to the threads of the

locking thumbscrew (see

excess grease.

Figure 42 – Apply grease to threads of the thumbscrew

Carefully screw the freshly greased locking screw into

the tapped hole in the BHSU/BHTU pillar arm (see

Figure

43) until the ring groove in the end of the locking

thumbscrew is visible in the dovetail recess for the

viewing head (see

Figure

visible grease squeeze-out.

Figure 43 – Screw the thumbscrew into the tapped hole

Figure 44 – The ring groove for the retaining e-clip

Figure

42). Wipe away any

44). Thoroughly remove any

Revision 1

Page 16 of 45