Axkid Rekid Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Bebé & Muebles para niños pequeños Axkid Rekid. Axkid Rekid 16 páginas.

needs to be repeated on both sides to cre-

ate two anchor points. When installing

Rekid in the front passenger seat the tether

straps must be attached to the front gliding

tracks so the tether points will be located

along the front edge of the passenger seat.

Pull out the upper anchorage strap from

the belt housing (7) to an appropriate

length. Check that the white marking on

the strap (8) is visible. If not, you can try

crossing the straps over to give them some

extra length to enable the white marking

to be visible. Clip the anchor attachment

directly onto the anchorage point. Repeat

on the other side. Press down hard on the

on the top right side of the child restraint

then repeat for the left side(9). When you

do this its important that you really use

your full body weight to press down and

get the tether straps to really tighten hard.

This will give the anchorage straps their

first tightening.

Unfold the support leg (10) out to its

maximum angle. Pull out the top latch

to release the upper part of the support leg

(11) until it reaches the floor. If the sup-

port leg does not reach the floor, repeat

with the lower latch (11). Its important

that you check that the support leg is an

angle over 80 degrees from the back of the

seat. You could check this by ensuring that

the support leg is further away from the

seat then the vertical line(12). Press down

on the child restraint from side to side

again, the anchorage straps will be then be

automatically tightened.

Continued on next page