ページを印刷する
9
9
needs to be repeated on both sides to cre-
ate two anchor points. When installing
Rekid in the front passenger seat the tether
straps must be attached to the front gliding
tracks so the tether points will be located
along the front edge of the passenger seat.
Pull out the upper anchorage strap from
the belt housing (7) to an appropriate
length. Check that the white marking on
the strap (8) is visible. If not, you can try
crossing the straps over to give them some
7
extra length to enable the white marking
to be visible. Clip the anchor attachment
8
directly onto the anchorage point. Repeat
on the other side. Press down hard on the
on the top right side of the child restraint
then repeat for the left side(9). When you
do this its important that you really use
your full body weight to press down and
get the tether straps to really tighten hard.
This will give the anchorage straps their
10
first tightening.
Unfold the support leg (10) out to its
maximum angle. Pull out the top latch
to release the upper part of the support leg
11
(11) until it reaches the floor. If the sup-
port leg does not reach the floor, repeat
with the lower latch (11). Its important
that you check that the support leg is an
angle over 80 degrees from the back of the
seat. You could check this by ensuring that
12
11
the support leg is further away from the
seat then the vertical line(12). Press down
on the child restraint from side to side
again, the anchorage straps will be then be
automatically tightened.
Continued on next page