Accurate Technology Digi-Stop Manual del usuario - Página 14
Navegue en línea o descargue pdf Manual del usuario para Instrumentos de medida Accurate Technology Digi-Stop. Accurate Technology Digi-Stop 16 páginas. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws
Programming Parameters
The Digi-Stop readout programming parameters are listed below.
Values in [ ] are the available range of values that can be entered for that
parameter. Factory defaults are shown in
Pr 1 – Datum Key
The programmed value that will be recalled whenever the
pressed during normal operation.
Default = 0.00
Pr 2 – Reverse Readings
This parameter controls the direction of travel (positive vs. negative) when the
stop is moved.
Default = 0
Pr 3 – Key Lockout
This parameter controls the operation of the +,
If enabled, (set to 1), these keys will not function and the LOCK
appear on the display. This prevents accidental changes when pressing these
keys during normal operation.
Default = 0
Pr 4 – Readout Resolution
This parameter sets the number of places to the right of the decimal point on
the readout.
A value of 1 – Low - will display x.x.
A value of 2 – Normal -will display x.xx
A value of 3 – High - will display x.xxx
Default = 2
NOTES:
Millimeters have a maximum of 2 places (even if parameter is set to 3.)
This setting has no effect when displaying fractions.
Manual Part # 800-1070-001, Rev G, 10-2008
[0
to + 999.999in] or
Bold
Red.
[0
to +9999.99mm]
[0
[0
-
and
DATUM
LOCK symbol will
LOCK
LOCK
[1, 2, 3 ]
key is
DATUM
or 1]
or 1]
keys.
Page 14 of 16