Accurate Technology Digi-Stop 사용자 설명서 - 페이지 14

{카테고리_이름} Accurate Technology Digi-Stop에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Accurate Technology Digi-Stop 16 페이지. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws

페이지 인쇄

Programming Parameters

The Digi-Stop readout programming parameters are listed below.

Values in [ ] are the available range of values that can be entered for that

parameter. Factory defaults are shown in

Pr 1 – Datum Key

The programmed value that will be recalled whenever the

pressed during normal operation.

Default = 0.00

Pr 2 – Reverse Readings

This parameter controls the direction of travel (positive vs. negative) when the

stop is moved.

Default = 0

Pr 3 – Key Lockout

This parameter controls the operation of the +,

If enabled, (set to 1), these keys will not function and the LOCK

appear on the display. This prevents accidental changes when pressing these

keys during normal operation.

Default = 0

Pr 4 – Readout Resolution

This parameter sets the number of places to the right of the decimal point on

the readout.

A value of 1 – Low - will display x.x.

A value of 2 – Normal -will display x.xx

A value of 3 – High - will display x.xxx

Default = 2

NOTES:

Millimeters have a maximum of 2 places (even if parameter is set to 3.)

This setting has no effect when displaying fractions.

Manual Part # 800-1070-001, Rev G, 10-2008

to + 999.999in] or

Bold

Red.

to +9999.99mm]

and

DATUM

LOCK symbol will

LOCK

[1, 2, 3 ]

key is

DATUM

or 1]

keys.

Page 14 of 16