AXT ELECTRONIC VSD Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Maquinaria agrícola AXT ELECTRONIC VSD. AXT ELECTRONIC VSD 6 páginas. Electronic doorkeeper
Imprimir página
➊
Predator protection bar
(optional)
➋
Predator protection bar
(optional)
upper
xing holes
outside
Mounting notes: There must be no upper stop / blockade! Switching off during opening and closing is carried out
via switches in the device. The weight of the slider must be between 200 g and max. 3.0 kg. The maximum stroke of
the pull cord is 70 cm. To prevent the slider from freezing in winter, coat the rails with a little grease. The cord and the
inside of the doorkeeper must not be wetted with oil or grease.
If the installation is not possible or desired directly above the slider, please observe the separate instructions on our
website. To extend the connecting cord between slider and doorkeeper, only one additional cord may be used (wit-
hout coticeable self-weight), but no chain or karabiner, as a additional weight of chain or karabiner deactivates the
automatic switch-off when the slider is closed.
lower
xing holes
inside
MOUNTING
Electronic Doorkeeper VSD
1. Mount the lateral guide rail vertically (spirit level). Al-
ways align the upper hole to the outside. If an optional
protective rail is available, use it to mark the lower
fixing holes. Align the protective rail horizontally.
2. Hold on slide and mark the position of the second
guide rail. Make sure that there is sufficient clearance
for the slider between the two guide rails. Fasten the
second guide rail.
3. Now connect the Doorkeeper VSD to the slider (fix the
cord to the slider) and insert the slider plate into the
rails. Bring the slider together with the Doorkeeper
into the desired upper position (door open). The line
of the Doorkeeper must be exactly vertical. Mark the
position of the Doorkeeper.
4. Unscrew the Doorkeeper's cover and fix it at the
marked position.
5. Install all optional accessories such as timer, external
LED, external manual control or external twilight
sensor (see wiring diagram on next page).
START-UP
Electronic Doorkeeper VSD
1. Insert batteries or connect mains adapter. After a
short initialization, the Doorkeeper is in the open
state and ready for operation.
2. The bottom stop of the slide is automatically de-
tected by the Doorkeeper during operation. Please
check by a first closing process by means of the
manual control (red magnet) (slide must not block
when closing). Then reopen the slide again with the
manual control.
3. Check the function of the twilight sensor by dar-
kening the Doorkeeper (with thick black jacket or
similar). The closing process is activated approx. 2-3
seconds after darkening. After the slider has closed
completely, restore the daylight situation. Opening
takes place with a delay of approx. 10-12 seconds.
The Electronic Doorkeeper is now ready for use.
General information: In the delivery condition, the Door-
keeper is designed for operation with an internal twilight
sensor. When installing a timer, please note the instruc-
tions on programming the various control options on the
following pages. A long battery life is guaranteed if you
only use AA Mignon alkaline batteries! If the batteries in
your new device last only a few days or weeks, there is
most likely a mounting error (e.g. slide blockage). Please
check by manual operation with the red magnet whether
the slide can open completely (limit switch by contact in
the Doorkeeper).