AXT ELECTRONIC VSD Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Pertanian AXT ELECTRONIC VSD. AXT ELECTRONIC VSD 6 halaman. Electronic doorkeeper

Halaman Cetak

➊

Predator protection bar

(optional)

➋

Predator protection bar

(optional)

upper

xing holes

outside

Mounting notes: There must be no upper stop / blockade! Switching off during opening and closing is carried out

via switches in the device. The weight of the slider must be between 200 g and max. 3.0 kg. The maximum stroke of

the pull cord is 70 cm. To prevent the slider from freezing in winter, coat the rails with a little grease. The cord and the

inside of the doorkeeper must not be wetted with oil or grease.

If the installation is not possible or desired directly above the slider, please observe the separate instructions on our

website. To extend the connecting cord between slider and doorkeeper, only one additional cord may be used (wit-

hout coticeable self-weight), but no chain or karabiner, as a additional weight of chain or karabiner deactivates the

automatic switch-off when the slider is closed.

lower

xing holes

inside

MOUNTING

Electronic Doorkeeper VSD

1. Mount the lateral guide rail vertically (spirit level). Al-

ways align the upper hole to the outside. If an optional

protective rail is available, use it to mark the lower

fixing holes. Align the protective rail horizontally.

2. Hold on slide and mark the position of the second

guide rail. Make sure that there is sufficient clearance

for the slider between the two guide rails. Fasten the

second guide rail.

3. Now connect the Doorkeeper VSD to the slider (fix the

cord to the slider) and insert the slider plate into the

rails. Bring the slider together with the Doorkeeper

into the desired upper position (door open). The line

of the Doorkeeper must be exactly vertical. Mark the

position of the Doorkeeper.

4. Unscrew the Doorkeeper's cover and fix it at the

marked position.

5. Install all optional accessories such as timer, external

LED, external manual control or external twilight

sensor (see wiring diagram on next page).

START-UP

Electronic Doorkeeper VSD

1. Insert batteries or connect mains adapter. After a

short initialization, the Doorkeeper is in the open

state and ready for operation.

2. The bottom stop of the slide is automatically de-

tected by the Doorkeeper during operation. Please

check by a first closing process by means of the

manual control (red magnet) (slide must not block

when closing). Then reopen the slide again with the

manual control.

3. Check the function of the twilight sensor by dar-

kening the Doorkeeper (with thick black jacket or

similar). The closing process is activated approx. 2-3

seconds after darkening. After the slider has closed

completely, restore the daylight situation. Opening

takes place with a delay of approx. 10-12 seconds.

The Electronic Doorkeeper is now ready for use.

General information: In the delivery condition, the Door-

keeper is designed for operation with an internal twilight

sensor. When installing a timer, please note the instruc-

tions on programming the various control options on the

following pages. A long battery life is guaranteed if you

only use AA Mignon alkaline batteries! If the batteries in

your new device last only a few days or weeks, there is

most likely a mounting error (e.g. slide blockage). Please

check by manual operation with the red magnet whether

the slide can open completely (limit switch by contact in

the Doorkeeper).