Axxess AXDIS-GM13 Manual de instrucciones de instalación - Página 3

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipos de grabación Axxess AXDIS-GM13. Axxess AXDIS-GM13 16 páginas. Gm data interface withswc2005-2011

Imprimir página

CONNECTIONS

3.5mm jack steering wheel control retention:

• The 3.5mm jack is to be used to retain audio controls on the steering wheel.

For the radios listed below: Connect the 3.5mm adapter to the male 3.5mm SWC jack

•

from the AXDIS-GM13 harness. Any remaining wires tape off and disregard.

•

Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/

White wire of the connector. Then connect the remaining steering wheel control

wire, normally Brown/White, to the Brown wire of the connector .

•

Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.

•

Kenwood or select JVC with a steering wheel control wire: Connect the Blue/

Yellow wire to the Brown wire.

Note: If your Kenwood radio auto detects as a JVC, manually set the radio type to

Kenwood. See the instructions under changing radio type.

•

XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.

•

Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AXSWCH-PAR (sold

separately), and then connect the 4-pin connector from the AXSWCH-PAR into the radio.

Note: The radio must be updated to rev. 2.1.4 or higher software.

•

Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to

as Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining

steering wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire

of the connector. If the radio comes with a third wire for ground, disregard this wire

Note: After the interface has been programmed to the vehicle, refer to the

manual provided with the radio for assigning the SWC buttons. Contact the radio

manufacturer for more information.

• For all other radios: Connect the 3.5mm jack from the AXDIS-GM13 harness into

the jack on the aftermarket radio designated for an external steering wheel control

interface. Please refer to the aftermarket radios manual if in doubt as to where the

3.5mm jack connects.

(CONT)

INSTALLATION

With the key in the off position:

• Connect the 16-pin harness, and the AXDIS-GM13 harness, into the AXDIS-GM13 interface.

Attention! Do not connect the AXDIS-GM13 harness to the wiring harness in the vehicle just yet.

Attention! If retaining steering wheel controls, ensure that the jack/wire is connected to the radio before

proceeding. If this step is skipped, the interface will need to be reset for the steering wheel controls to function.

ADJUSTING THE AXDIS-GM13

Audio level adjustment:

• With the vehicle and radio turned on, turn the volume up 3/4 of the way.

• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio level;

counterclockwise to lower the audio level.

• Once at a desired level, audio level adjustment is complete.

Chime level adjustment:

• While the chimes are playing, press the VOLUME UP or VOLUME DOWN button on the steering wheel to raise

or lower the sound level of your chimes.

OnStar

level adjustment:

• Press the OnStar

button to activate it.

• While OnStar

is speaking, press the VOLUME UP or VOLUME DOWN button on the steering wheel to raise or

lower the OnStar

level.

REV. 3/6/23 INSTAXDIS-GM13