Axxess AXDIS-GM13 Manual de instrucciones de instalación - Página 4
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipos de grabación Axxess AXDIS-GM13. Axxess AXDIS-GM13 16 páginas. Gm data interface withswc2005-2011
Imprimir páginaFor the steps below, the L.E.D. located inside the interface can only be seen while active. The interface does
not need to be opened to see the L.E.D.
1. Start the vehicle.
2. Connect the AXDIS-GM13 harness to the wiring harness in the vehicle.
3. The L.E.D. will initially turn on solid Green, then turn off for a few seconds while it auto detects the
radio installed.
4. The L.E.D. will then flash Red up to (23) times indicating which radio is connected to the interface, and
then turn off for a couple of seconds. Pay close attention to how many Red flashes there are. This will
help in troubleshooting, if need be. Refer to the L.E.D. feedback section for more information.
5. After a couple seconds the L.E.D. will turn on solid Red while the interface auto detects the vehicle. The
radio will shut off at this point. This process should take 5 to 30 seconds.
6. Once the vehicle has been auto detected by the interface, the L.E.D. will turn on solid Green, and the
radio will come back on, indicating programming was successful.
7. Test all functions of the installation for proper operation, before reassembling the dash. If the interface
fails to function, refer to Troubleshooting section.
Note: The L.E.D. will turn on solid Green for a moment, and then turn off under normal operation after
the key has been cycled.
4