Axxess CHTO-013 Instrucciones de instalación

Navegue en línea o descargue pdf Instrucciones de instalación para Amplificador Axxess CHTO-013. Axxess CHTO-013 2 páginas. Chrysler can bus interface

Imprimir página

CHTO-013

* IMPORTANT WARNING

THIS PRODUCT INCLUDES INSTRUCTIONS FOR INSTALLATION WHICH MUST

BE CAREFULLY FOLLOWED. THE INSTRUCTIONS ARE WORDED IN SUCH A

MANNER TO ASSUME THAT THE INSTALLER IS CAPABLE OF COMPLETING

THESE TYPE OF ELECTRONIC INSTALLATIONS. IF YOU ARE UNCLEAR AS TO

WHAT YOU ARE INSTRUCTED TO DO OR BELIEVE THAT YOU DO NOT UNDER-

STAND THE INSTRUCTIONS SO AS TO PROPERLY AND SAFELY COMPLETE

THE INSTALLATION YOU SHOULD CONSULT A TECHNICIAN WHO DOES HAVE

THIS KNOWLEDGE AND UNDERSTANDING. FAILURE TO FOLLOW THESE

INSTRUCTIONS CAREFULLY AND TO INSTALL THE INTERFACE AS

DESCRIBED COULD CAUSE HARM TO THE VEHICLE OR TO SAFETY

SYSTEMS ON THE VEHICLE. INTERFERENCE WITH CERTAIN SAFETY

SYSTEMS COULD CAUSE HARM TO PERSONS AS WELL. IF YOU HAVE ANY

QUESTIONS IN THIS REGARD PLEASE CALL THE HELP LINE OR THE

METRA AT 1-800-221-0932 FOR ASSISTANCE.

CHTO-013

AUDIO LEVEL CONTROL

POTENTIOMETER

AUDIO LEVEL

ADJUSTMENT

When using the CHTO-013 with a radio that has a high audio pre-out voltage,

usually greater than 2 volts, the audio signal may become distorted.

To resolve this follow these steps:

1. Make sure the ignition is turned to the "off" position.

2. Disconnect both of the harnesses from the CHTO-013.

3. Locate the potentiometer next to the 14 pin connector at the end of the CHTO-013.

4. Taking a small flat headed screwdriver, turn the potentiometer counter-

clockwise to lower the input level going to the factory amplifier.

5. After making the adjustment reconnect the wire harnesses.

CHRYSLER CAN BUS INTERFACE

CHTO-013

INSTALLATION INSTRUCTIONS

* READ IMPORTANT WARNING INSIDE

BEFORE ATTEMPTING ANY INSTALLATION

THE CHTO-013 IS DESIGNED TO BE USED WITH VEHI-

CLES THAT HAVE A FACTORY AMPLIFIED SYSTEM. THE

CHTO-013 WILL PROVIDE A 12VOLT SWITCHED WIRE

FOR PROPER RADIO OPERATION. THE CHTO-013 NOW

PROVIDES MUTE, PARKING BRAKE, VSS OR SPEED

SENSE, AND A REVERSE OUTPUT TO MAKE

INSTALLING AN AFTERMARKET NAVIGATIONAL RADIO

SIMPLER AND LESS TIME COMSUMING.

INTERFACE COMPONENTS

• CHTO-013

• 14 PIN HARNESS WITH RCA'S

• (2) 12 PIN HARNESSES TO 22 PIN CHRYSLER HARNESSES

TOOLS REQUIRED FOR INSTALLATION

• Cutting Tool • Tape • Crimping Tool • Connectors

REV. 05-10-10

1-800-221-0932

www.metraonline.com

INSTCHTO-013