アンプ Axxess CHTO-013のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Axxess CHTO-013 2 ページ。 Chrysler can bus interface
ページを印刷するCHTO-013
* IMPORTANT WARNING
THIS PRODUCT INCLUDES INSTRUCTIONS FOR INSTALLATION WHICH MUST
BE CAREFULLY FOLLOWED. THE INSTRUCTIONS ARE WORDED IN SUCH A
MANNER TO ASSUME THAT THE INSTALLER IS CAPABLE OF COMPLETING
THESE TYPE OF ELECTRONIC INSTALLATIONS. IF YOU ARE UNCLEAR AS TO
WHAT YOU ARE INSTRUCTED TO DO OR BELIEVE THAT YOU DO NOT UNDER-
STAND THE INSTRUCTIONS SO AS TO PROPERLY AND SAFELY COMPLETE
THE INSTALLATION YOU SHOULD CONSULT A TECHNICIAN WHO DOES HAVE
THIS KNOWLEDGE AND UNDERSTANDING. FAILURE TO FOLLOW THESE
INSTRUCTIONS CAREFULLY AND TO INSTALL THE INTERFACE AS
DESCRIBED COULD CAUSE HARM TO THE VEHICLE OR TO SAFETY
SYSTEMS ON THE VEHICLE. INTERFERENCE WITH CERTAIN SAFETY
SYSTEMS COULD CAUSE HARM TO PERSONS AS WELL. IF YOU HAVE ANY
QUESTIONS IN THIS REGARD PLEASE CALL THE HELP LINE OR THE
METRA AT 1-800-221-0932 FOR ASSISTANCE.
CHTO-013
AUDIO LEVEL CONTROL
POTENTIOMETER
AUDIO LEVEL
ADJUSTMENT
When using the CHTO-013 with a radio that has a high audio pre-out voltage,
usually greater than 2 volts, the audio signal may become distorted.
To resolve this follow these steps:
1. Make sure the ignition is turned to the "off" position.
2. Disconnect both of the harnesses from the CHTO-013.
3. Locate the potentiometer next to the 14 pin connector at the end of the CHTO-013.
4. Taking a small flat headed screwdriver, turn the potentiometer counter-
clockwise to lower the input level going to the factory amplifier.
5. After making the adjustment reconnect the wire harnesses.
4
CHRYSLER CAN BUS INTERFACE
CHTO-013
INSTALLATION INSTRUCTIONS
* READ IMPORTANT WARNING INSIDE
BEFORE ATTEMPTING ANY INSTALLATION
THE CHTO-013 IS DESIGNED TO BE USED WITH VEHI-
CLES THAT HAVE A FACTORY AMPLIFIED SYSTEM. THE
CHTO-013 WILL PROVIDE A 12VOLT SWITCHED WIRE
FOR PROPER RADIO OPERATION. THE CHTO-013 NOW
PROVIDES MUTE, PARKING BRAKE, VSS OR SPEED
SENSE, AND A REVERSE OUTPUT TO MAKE
INSTALLING AN AFTERMARKET NAVIGATIONAL RADIO
SIMPLER AND LESS TIME COMSUMING.
INTERFACE COMPONENTS
• CHTO-013
• 14 PIN HARNESS WITH RCA'S
• (2) 12 PIN HARNESSES TO 22 PIN CHRYSLER HARNESSES
TOOLS REQUIRED FOR INSTALLATION
• Cutting Tool • Tape • Crimping Tool • Connectors
REV. 05-10-10
1-800-221-0932
www.metraonline.com
©Copyright 2004-2010 Metra Electronics Corporation
INSTCHTO-013