Accurion i4 Series Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Equipos de laboratorio Accurion i4 Series. Accurion i4 Series 14 páginas. Active vibration isolation halcyonics workstation
Imprimir página4. Safety Instructions and Warnings
Please read through the following safety instructions and warnings carefully before using this equipment.
General Warnings
Do not operate the system in a potentially explosive or humid environment. Do not switch on the system
if there is any visible damage or if you think it might be damaged. In this case, turn off the power
immediately and notify our distributor in your area or contact Accurion's headquarters in Germany
directly.
Electrical Safety
This system may be operated only on AC grounded power. Do not interrupt the protective grounding
conductor under any circumstances. If you plan to use a power cable other than the standard power cord
supplied with this equipment, first check that the protective grounding conductor is connected.
Before starting to operate this equipment, check the voltage rating to be sure that it matches your local
voltage. For further information, please refer to the specifications on page 10.
Finish the set up and installation before attempting to plug it into an electrical outlet. Never open the
equipment housing. Only authorized and qualified personnel may service or repair the equipment.
The device must be connected to an easily accessible supply socket so that in the event of a
malfunction, the supply plug can be removed quickly.
Mechanical Safety
Be sure that the workstation is installed on a rigid floor.
Please note that you need to activate the transport/relocation locking mode before you
transport or move the equipment! For further instructions, please refer to the section "Automatic
Load Adjustment and Transport Locking Mode" on page 7.
Intended Use
The system is suited to isolate various measurement equipment from building vibration and other
disturbing influences. Every other use is not permitted.
Never use the isolation system in mobile environments or outside the specified environmental
and operational requirements, see page 10.
DIN and European Standards, European Council Directives
Halcyonics Workstation_i4 systems conform to the requirements currently valid for electrical safety
according to EC Directive 2006/95/EC and for electromagnetic compatibility according to EC Directive
2004/108/EC. This equipment has been tested and found to comply with the following standards EN
61010-1:2010.
- 4 -