Digimax 210 Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Termostato Digimax 210. Digimax 210 12 páginas. Programmable thermostat compatible with maxi controller
También para Digimax 210: Manual del usuario (11 páginas)
Imprimir página2. Within the 5 minute install period go to the RF-Max Re-
ceiver. Press and hold the Install button and then press
the Test button while the Install button is held. This will
clear out any previously installed codes. The Red Led will
pulse slowly for 3 seconds to indicate this has been done.
3. Next, place the Receiver in Install mode by pressing and
holding the Install button (for at least 10 seconds). The
Red LED will come on and stay on until a valid Install
Code has been received. When this happens the Red
LED will start pulsing slowly and the install button can
then be released. The Red LED will pulse for a further 5
seconds and then go off. The Install code has been
successfully received.
4. Go to the Thermostat Transmitter and press any key to
stop the transmission. The display will stop flashing ']]]'
and return to normal.
5. The R-Max Receiver will now only respond to radio sig-
nals with the installed code i.e. from the DigiMax 210 Ther-
mostat just installed. Even if the power is removed from
the Receiver it will not forget the installed code.
6. Check that the DigiMax 210 and the RF-Max are commu-
nicating with each other by adjusting the Digimax 210
Thermostat set point above or below the actual tempera-
ture thus generating a radio signal. This will happen every
time the DigiMax 210 Thermostat calls for heating / cool-
ing to be switched on or off.
7. The DigiMax 210 Thermostat also sends a radio signal
every 5 minutes to make sure that the RF-Max Receiver
knows what state it should be in. Therefore every 5 min-