Digimax 210 사용자 설명서 - 페이지 8

{카테고리_이름} Digimax 210에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digimax 210 12 페이지. Programmable thermostat compatible with maxi controller
Digimax 210에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

페이지 인쇄

2. Within the 5 minute install period go to the RF-Max Re-

ceiver. Press and hold the Install button and then press

the Test button while the Install button is held. This will

clear out any previously installed codes. The Red Led will

pulse slowly for 3 seconds to indicate this has been done.

3. Next, place the Receiver in Install mode by pressing and

holding the Install button (for at least 10 seconds). The

Red LED will come on and stay on until a valid Install

Code has been received. When this happens the Red

LED will start pulsing slowly and the install button can

then be released. The Red LED will pulse for a further 5

seconds and then go off. The Install code has been

successfully received.

4. Go to the Thermostat Transmitter and press any key to

stop the transmission. The display will stop flashing ']]]'

and return to normal.

5. The R-Max Receiver will now only respond to radio sig-

nals with the installed code i.e. from the DigiMax 210 Ther-

mostat just installed. Even if the power is removed from

the Receiver it will not forget the installed code.

6. Check that the DigiMax 210 and the RF-Max are commu-

nicating with each other by adjusting the Digimax 210

Thermostat set point above or below the actual tempera-

ture thus generating a radio signal. This will happen every

time the DigiMax 210 Thermostat calls for heating / cool-

ing to be switched on or off.

7. The DigiMax 210 Thermostat also sends a radio signal

every 5 minutes to make sure that the RF-Max Receiver

knows what state it should be in. Therefore every 5 min-