Crescent SC6500 Manual de uso y mantenimiento - Página 2

Navegue en línea o descargue pdf Manual de uso y mantenimiento para Fregadora Crescent SC6500. Crescent SC6500 2 páginas.
También para Crescent SC6500: Manual de solución de problemas (2 páginas)

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.
1. Check the battery charge gauge
(and if necessary re-charge)
6. Install squeegee
10. If necessary open the solution filter
cage and clean the net.
14. Adjust water flow.
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
2. Check that the drive pedal is re -
sponding and all circuit breakers are
armed
7. Check the height of the squeegee by
adjusting the castor wheels and the
angle knob.
15. Adjust detergent flow.
3. Check battery cables are well con -
nected together
11. Install Brushes.
16. In case something does not work
enter the Service test mode by press -
ing the Speed switch and the trac -
tion control switch, then on the key.
Go through the menu.
4. Recovery tank seal cover must
correctly installed and in good
condition
8. Open broom door compartment and
check presence of ropes or debris
that can block it.
12. Adjust side skirts height
www.crescentindustrial.co.uk
SC6500
5. Inspect the squeegee blades for cuts
or chunks
9. Check presence of water in the
solution tank.
13. Make sure that deck and squeegee
are moving down when pressing
the button.