Crescent SC6500 사용자 및 유지보수 매뉴얼 - 페이지 2

{카테고리_이름} Crescent SC6500에 대한 사용자 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crescent SC6500 2 페이지.
Crescent SC6500에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (2 페이지)

페이지 인쇄

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual.

1. Check the battery charge gauge

(and if necessary re-charge)

6. Install squeegee

10. If necessary open the solution ﬁlter

cage and clean the net.

14. Adjust water ﬂow.

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to

carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

2. Check that the drive pedal is re -

sponding and all circuit breakers are

armed

7. Check the height of the squeegee by

adjusting the castor wheels and the

angle knob.

15. Adjust detergent ﬂow.

3. Check battery cables are well con -

nected together

11. Install Brushes.

16. In case something does not work

enter the Service test mode by press -

ing the Speed switch and the trac -

tion control switch, then on the key.

Go through the menu.

4. Recovery tank seal cover must

correctly installed and in good

condition

8. Open broom door compartment and

check presence of ropes or debris

that can block it.

12. Adjust side skirts height

www.crescentindustrial.co.uk

SC6500

5. Inspect the squeegee blades for cuts

or chunks

9. Check presence of water in the

solution tank.

13. Make sure that deck and squeegee

are moving down when pressing

the button.