Cresco 10W Montaje - Página 2

Navegue en línea o descargue pdf Montaje para Esparcidor Cresco 10W. Cresco 10W 2 páginas.

Push the plastic end cap into the centre hole of the axle. Use

screwdriver and wheel cap screw to tighten. Complete on both

sides.

ASSEMBLING THE HANDLE BAR AND CONTROL ROD:

Flip the spreader onto its wheels and

ensure they work correctly. Align the holes

at the bottom of the handle bar (item 2)

with the holes at the top of the

x 50(11)

frame

Before tightening the control rod. Make sure

the application holes in the hopper are fully

open and the control lever is set at 20.

Protruding from the back of the hopper

body (item 16) is a V-shaped metal called a

pivot bracket pictured above. Clip the L

shaped end of the control rod (item 1 )

into the hole on the pivot bracket.(item 20)

IMPORTANT

www.crescospreaders.com

Assembly of Cresco 10

Flip the spreader onto its wheels and ensure they work correctly.

Align the holes at the bottom of the handle bar (item 2) with the

holes at the top of the lower frame (item 1 ). You may need to

pull the ends apart slightly to place in position.

Afﬁx the agitator pin (item 8) through the

impeller shaft inside the hopper.

FINAL TOUCHES