Cresco 10W Assembly - Page 2
Parcourez en ligne ou téléchargez le pdf Assembly pour {nom_de_la_catégorie} Cresco 10W. Cresco 10W 2 pages.
D
Push the plastic end cap into the centre hole of the axle. Use
screwdriver and wheel cap screw to tighten. Complete on both
sides.
ASSEMBLING THE HANDLE BAR AND CONTROL ROD:
7
Flip the spreader onto its wheels and
ensure they work correctly. Align the holes
at the bottom of the handle bar (item 2)
with the holes at the top of the
x 50(11)
frame
10
Before tightening the control rod. Make sure
the application holes in the hopper are fully
open and the control lever is set at 20.
8
Protruding from the back of the hopper
body (item 16) is a V-shaped metal called a
pivot bracket pictured above. Clip the L
shaped end of the control rod (item 1 )
into the hole on the pivot bracket.(item 20)
11
IMPORTANT
www.crescospreaders.com
Assembly of Cresco 10
6
Flip the spreader onto its wheels and ensure they work correctly.
Align the holes at the bottom of the handle bar (item 2) with the
holes at the top of the lower frame (item 1 ). You may need to
pull the ends apart slightly to place in position.
9
12
Affix the agitator pin (item 8) through the
impeller shaft inside the hopper.
FINAL TOUCHES