Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalación - Página 15

Navegue en línea o descargue pdf Nota de instalación para Interruptor Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 28 páginas. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
También para Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota de instalación (14 páginas), Manual de soluciones (17 páginas), Nota de instalación (46 páginas), Libro Blanco (19 páginas), Descripción (1 páginas), Boletín de productos (6 páginas), Aviso (4 páginas), Ficha de datos (9 páginas), Ficha de datos (18 páginas), Libro Blanco (18 páginas), Manual de configuración (8 páginas), Manual de solución de problemas (11 páginas), Nota de instalación (18 páginas), Manual del usuario (17 páginas), Nota de instalación (24 páginas), Manual (19 páginas), Nota de instalación (36 páginas)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalación
Figure 2
Insert module
between slot guides
Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the
Step 6
following sets of substeps:
Horizontal slots
Position the supervisor engine or module in the slot. Make sure that you align the sides of the module
a.
carrier with the slot guides on each side of the slot. (See
Carefully slide the supervisor engine or module into the slot until the EMI gasket along the top edge
b.
of the module makes contact with the module in the slot above it and both ejector levers have closed
to approximately 45 degrees with respect to the module faceplate. (See
78-15751-03
Positioning the Module in a Horizontal Slot Chassis
EMI gasket
3
4
4
5
5
6
6
WS-X6K-SUP2-2 GE
1
CONSOLE
CONSOLE
SUPERVISOR2
WS-X6K-SUP2-2 GE
2
CONSOLE
CONSOLE
SUPERVISOR2
3
4
5
6
WS-X6224
24 PORT 100FX
EMI gasket
o
WS-C 6500- SFM
SWIT CH FABR IC MDL
Ejector lever fully
extended
Catalyst 6500 Series Switch Content Switching Module Installation Note
Switch
Load
100%
PORT
PORT 1
MODE
PORT 2
PCMCIA
EJECT
1%
Switch
Load
100%
PORT
PORT 1
MODE
PORT 2
PCMCIA
EJECT
1%
o
INPUT
FAN
OUTPU T
OK
OK
FAIL
Installing the CSM
INPUT
FAN
OUTPU T
OK
OK
FAIL
Figure
2.)
Figure
3.)
15