Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Interruptor Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 17 páginas. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
También para Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota de instalación (14 páginas), Manual de soluciones (17 páginas), Nota de instalación (46 páginas), Libro Blanco (19 páginas), Descripción (1 páginas), Boletín de productos (6 páginas), Aviso (4 páginas), Ficha de datos (9 páginas), Ficha de datos (18 páginas), Libro Blanco (18 páginas), Manual de configuración (8 páginas), Nota de instalación (28 páginas), Manual de solución de problemas (11 páginas), Nota de instalación (18 páginas), Nota de instalación (24 páginas), Manual (19 páginas), Nota de instalación (36 páginas)

Imprimir página
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manual del usuario
% Recommended aging time for all vlans is atleast three times the activity interval
Dist−VSS# clear mac−address−table dynamic
% MAC entries cleared.
Dist−VSS# show mac−address−table synchronize statistics
MAC Entry Out−of−band Synchronization Feature Statistics:
−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−−
Switch [1] Module [4]
−−−−−−−−−−−−−−−−−−−−−
Module Status:
Statistics collected from Switch/Module
Number of L2 asics in this module
Global Status:
Status of feature enabled on the switch
Default activity time
Configured current activity time
VSS Terminology
•
Virtual Switch Link (VSL)A special port channel required to bundle two physical switches into
one virtual switch.
•
VSL Protocol (VSLP)Runs between active and standby switch over the VSL, and has two
components: LMP and RRP
♦
Link Management Protocol (LMP)Runs over each individual link in VSL
♦
Role Resolution Protocol (RRP)Runs on each side (each peer) of the VSL port channel
Capacity Planning for VSL
Ideally in dual−homed VSS configuration, no data traffic is sent on the VSL link. Each switch is programmed
to choose its local interfaces for traffic forwarding.
Additional VSL link capacity planning is required for traffic carried by:
•
Single homed devices
•
Remote SPAN from one switch to another
•
Service module traffic †FWSM, ACE, etc.
: 1/4
: 1
: on
: 160
: 480