Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota de instalación - Página 10

Navegue en línea o descargue pdf Nota de instalación para Interruptor Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 36 páginas. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
También para Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota de instalación (14 páginas), Manual de soluciones (17 páginas), Nota de instalación (46 páginas), Libro Blanco (19 páginas), Descripción (1 páginas), Boletín de productos (6 páginas), Aviso (4 páginas), Ficha de datos (9 páginas), Ficha de datos (18 páginas), Libro Blanco (18 páginas), Manual de configuración (8 páginas), Nota de instalación (28 páginas), Manual de solución de problemas (11 páginas), Nota de instalación (18 páginas), Manual del usuario (17 páginas), Nota de instalación (24 páginas), Manual (19 páginas)

Removing a CFC or DFC3 Daughter Card

If you are upgrading one of the WS-X67xx Ethernet modules listed in

card, you must remove the CFC or the DFC3 daughter card before installing the new DFC4 daughter

card. The following two procedures are provided:

•

Once you have replaced the DFC3 daughter card with a DFC4 daughter card, the module will only

Note

operate with the Supervisor Engine 2T.

Removing the CFC Daughter Card

If your WS-X67xx Ethernet module is equipped with a CFC daughter card, you must remove it before

you install the DFC4 daughter card.

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

To remove a CFC daughter card, follow these steps:

Attach an ESD grounding strap to your wrist and to ground.

Step 1

Remove the Ethernet module from the Catalyst 6500 series switch.

Step 2

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

instructions.

Place the Ethernet module on an antistatic mat with the front of the module facing toward you.

Step 3

Catalyst 6500 Series Distributed Forwarding Card 4 for WS-X68xx, WS-X69xx, and Select WS-X67xx Modules Installation Note

Removing the CFC Daughter Card, page 10

Removing the DFC3 Daughter Card, page 14

"Removing and Installing Ethernet Modules in the Chassis" section on page 28

Table 2

with a DFC4 daughter

for removal

OL-24918-02