Cisco 9124 - mds multilayer fabric switch Nota de publicación - Página 18

Navegue en línea o descargue pdf Nota de publicación para Interruptor Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 44 páginas. Mds 9000 series
También para Cisco 9124 - mds multilayer fabric switch: Especificaciones (2 páginas), Ficha de datos (9 páginas), Especificaciones (3 páginas), Manual de configuración (49 páginas), Nota de publicación (48 páginas), Nota de publicación (36 páginas), Nota de publicación (22 páginas), Nota de publicación (3 páginas), Nota de publicación (40 páginas), Manual (16 páginas), Manual de instalación del hardware (36 páginas)

Upgrading Your Cisco MDS SAN-OS Software Image

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Note

Check the syslogs for any ISL that was isolated.

Step 3

2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED:

%$VSAN 2005%$ Isolation of interface

port-channel 52 (reason: unknown failure)

2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED: %$VSAN 2005%$

Isolation of interface port-channel 51

(reason: domain ID assignment failure)

Issue the following commands for the isolated switches in Step 3:

Step 4

switch(config)# vsan database

switch(config-vsan-db)# vsan vsan-id suspend

switch(config-vsan-db)# no vsan vsan-id suspend

Step 5

Issue the ivr refresh command to perform an IVR refresh on all the IVR enabled switches.

Step 6

Issue the copy running-config startup-config command to save the RDI mode in the startup

configuration on all of the switches.

Step 7

Follow the normal upgrade guidelines for Release 2.1(2b). If you are adding new switches running Cisco

MDS SAN-OS Release 2.1(2b) or later, upgrade all of your existing switches to Cisco SAN-OS Release

2.1(2b) as described in this workaround. Then follow the normal upgrade guidelines for Release 3.3(3).

Note

Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(3)

Complete Step 2 for all IVR enabled switches before moving to Step 3.

RDI mode should not be disabled for VSANs running in interop mode 2 or interop mode 3.

OL-14116-11