Cisco Catalyst 3040 Manual de introducción - Página 17

Navegue en línea o descargue pdf Manual de introducción para Interruptor Cisco Catalyst 3040. Cisco Catalyst 3040 37 páginas. Catalyst blade switch for fsc

Completing the Initial Configuration

Follow these steps to complete the setup program and to create an initial configuration.
For information about how to automatically configure the blade switch, see the "Assigning
Note
the Switch IP Address and Default Gateway" chapter in the blade switch configuration guide.
After you have pressed Enter or Return after the prompt to start the system configuration
Step 1
dialog, enter yes at these prompts:
Would you like to terminate autoinstall? [yes]: yes
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Enter a hostname for the blade switch after the prompt, and press Return.
Step 2
The hostname is limited to 20 characters. Do not use -n, where n is a number, as the last
character in a host name for any blade switch.
Enter an enable secret password, and press Return.
Step 3
The password can be from 1 to 25 alphanumeric characters, can start with a number, is case
sensitive, allows spaces, but ignores leading spaces. The secret password is encrypted, and the
enable password is in plain text.
Enter an enable password, and press Return.
Step 4
Enter a virtual terminal (Telnet) password, and press Return.
Step 5
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces,
but ignores leading spaces.
17