Cisco Catalyst 3040 시작하기 매뉴얼 - 페이지 17

{카테고리_이름} Cisco Catalyst 3040에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3040 37 페이지. Catalyst blade switch for fsc

Completing the Initial Configuration

Follow these steps to complete the setup program and to create an initial configuration.

For information about how to automatically configure the blade switch, see the "Assigning

Note

the Switch IP Address and Default Gateway" chapter in the blade switch configuration guide.

After you have pressed Enter or Return after the prompt to start the system configuration

Step 1

dialog, enter yes at these prompts:

Would you like to terminate autoinstall? [yes]: yes

--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]: yes

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

Enter a hostname for the blade switch after the prompt, and press Return.

Step 2

The hostname is limited to 20 characters. Do not use -n, where n is a number, as the last

character in a host name for any blade switch.

Enter an enable secret password, and press Return.

Step 3

The password can be from 1 to 25 alphanumeric characters, can start with a number, is case

sensitive, allows spaces, but ignores leading spaces. The secret password is encrypted, and the

enable password is in plain text.

Enter an enable password, and press Return.

Step 4

Enter a virtual terminal (Telnet) password, and press Return.

Step 5

The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces,

but ignores leading spaces.