Cisco Catalyst 3040 시작하기 매뉴얼 - 페이지 16

{카테고리_이름} Cisco Catalyst 3040에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3040 37 페이지. Catalyst blade switch for fsc

Step 10 Go to "Waiting for POST to Complete" section on page 16 to finish configuring the blade
switch.
If the blade switch is already installed and powered up when you use the BX600 system management
blade console menu, you must reboot the switch to display the system configuration dialog:
1. Enter enable at the user EXEC (
(
) prompt.
Switch#
2. Follow the instructions in the next section, "Waiting for POST to Complete."

Waiting for POST to Complete

Follow these steps:
Step 1
Wait several minutes for the blade switch to complete the POST.
The POST is complete when the System Status/ID LED is off and the Console LED is solid
Step 2
green or amber.
If the blade switch fails POST because of a misconfiguration or error, the System Status/ID
LED blinks green and the Console LED is off.
POST errors are usually fatal. Call Cisco Customer Support immediately if your blade
Note
switch fails POST.
Wait for the blade switch to complete flash initialization. When you see the prompt Press
Step 3
Return to Get Started!, wait for any interface status information output to finish its
appearance, then press Return or Enter.
Make sure that the System Status/ID LED is off and that the Console LED is green or amber.
Step 4
The blade switch is now operating properly.
See the "Completing the Initial Configuration" section on page 17 for instructions on setting
Step 5
up and initially configuring the blade switch.
16
prompt, then enter reload at the privileged EXEC mode
Switch>)