Cisco Catalyst 3040 Manuale introduttivo - Pagina 16

Sfoglia online o scarica il pdf Manuale introduttivo per Interruttore Cisco Catalyst 3040. Cisco Catalyst 3040 37. Catalyst blade switch for fsc

Step 10 Go to "Waiting for POST to Complete" section on page 16 to finish configuring the blade

switch.

If the blade switch is already installed and powered up when you use the BX600 system management

blade console menu, you must reboot the switch to display the system configuration dialog:

1. Enter enable at the user EXEC (

(

) prompt.

Switch#

2. Follow the instructions in the next section, "Waiting for POST to Complete."

Waiting for POST to Complete

Follow these steps:

Step 1

Wait several minutes for the blade switch to complete the POST.

The POST is complete when the System Status/ID LED is off and the Console LED is solid

Step 2

green or amber.

If the blade switch fails POST because of a misconfiguration or error, the System Status/ID

LED blinks green and the Console LED is off.

POST errors are usually fatal. Call Cisco Customer Support immediately if your blade

Note

switch fails POST.

Wait for the blade switch to complete flash initialization. When you see the prompt Press

Step 3

Return to Get Started!, wait for any interface status information output to finish its

appearance, then press Return or Enter.

Make sure that the System Status/ID LED is off and that the Console LED is green or amber.

Step 4

The blade switch is now operating properly.

See the "Completing the Initial Configuration" section on page 17 for instructions on setting

Step 5

up and initially configuring the blade switch.

prompt, then enter reload at the privileged EXEC mode

Switch>)