Digisol DG-GS1510HPEV2 Manual de instalación del hardware - Página 10

Navegue en línea o descargue pdf Manual de instalación del hardware para Interruptor Digisol DG-GS1510HPEV2. Digisol DG-GS1510HPEV2 15 páginas.

Note:

DG-GS1510HPEV2 switch Console Port does not support flow control. Therefore, "Data Flow Control"

should be set "No" while using super terminal to manage switch.

 Console port connection

This cable is used to connect POE switch console port to external terminal. One end is

RJ45 8-pin plug. The other end is 9 –hole (DB9) plugs. RJ45 connector plugs into POE

switch console port. Use DB9 according to the terminal parallel port. The side of the

cable is shown as follows. The product No. of this cable is RLC0301.

Console port pins are as follows:

Pin No.

 Connecting Gigabit Ethernet Interface

POE switch provides 8 10/100/1000M ports. Each port is embedded with 2 LEDs to

indicate the statues of Link/ACT and PoE. Use switch UTP to connect to other Ethernet

terminals. UTP no. and console no. are the same. Refer to the following chart..

All of the 8 10/100/1000M ports of POE switch support auto-MDIX. Choose the

connection which best fits the connection between POE switch and Ethernet terminal.

10/100/1000M ports and other Ethernet terminal connection is shown as follows:

Description

No connect

Received data

signal ground

No connect

Transmitted data

No connect

Hardware Installation Guide

Name

Note

No connect

RXD

Input

GND

No connect

TXD

Output

No connect

- 8