Digisol DG-GS1510HPEV2 Instrukcja instalacji sprzętu - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji sprzętu dla Przełącznik Digisol DG-GS1510HPEV2. Digisol DG-GS1510HPEV2 15 stron.
Drukuj stronę
Note:
DG-GS1510HPEV2 switch Console Port does not support flow control. Therefore, "Data Flow Control"
should be set "No" while using super terminal to manage switch.
Console port connection
This cable is used to connect POE switch console port to external terminal. One end is
RJ45 8-pin plug. The other end is 9 –hole (DB9) plugs. RJ45 connector plugs into POE
switch console port. Use DB9 according to the terminal parallel port. The side of the
cable is shown as follows. The product No. of this cable is RLC0301.
Console port pins are as follows:
Pin No.
1
2
3
4
5
6
7
8
Connecting Gigabit Ethernet Interface
POE switch provides 8 10/100/1000M ports. Each port is embedded with 2 LEDs to
indicate the statues of Link/ACT and PoE. Use switch UTP to connect to other Ethernet
terminals. UTP no. and console no. are the same. Refer to the following chart..
All of the 8 10/100/1000M ports of POE switch support auto-MDIX. Choose the
connection which best fits the connection between POE switch and Ethernet terminal.
10/100/1000M ports and other Ethernet terminal connection is shown as follows:
-
Description
No connect
No connect
Received data
signal ground
No connect
Transmitted data
No connect
No connect
Hardware Installation Guide
Name
Note
NC
No connect
NC
No connect
RXD
Input
GND
GND
NC
No connect
TXD
Output
NC
No connect
NC
No connect
- 8