Sharp Aquos LC-19A1E Manual de instrucciones - Página 16
Navegue en línea o descargue pdf Manual de instrucciones para TV LCD Sharp Aquos LC-19A1E. Sharp Aquos LC-19A1E 28 páginas. Lcd colour television
Imprimir página
Menu operations
Power Control menu
MENU
[ Power Control ]
Audio
No Signal Off
No Operation Off
Power Management
No Signal Off
Menu Operation: A (page 11)
When set to "Enable" the TV will automatically enter
the standby mode if there is no signal input for 15
minutes.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
• "Disable" is the factory preset value.
No Operation Off
Menu Operation: A (page 11)
When you select the desired time, the TV will
automatically enter the standby mode if no operation
is performed.
Item
30 min. / 3hr. / Disable
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• "Disable" is the factory preset value.
Power Management
Menu Operation: A (page 11)
When set, the TV will automatically enter the standby
mode.
Item
Off:
• No power management
• Factory preset value
Mode1: • If there is no signal input for 8 minutes, the TV
enters the standby mode.
• Even if you start using the PC and the signal
inputs again, the TV stays in standby mode.
• The TV turns on again by pressing a on the TV
or B on the remote control unit. (See page 7.)
Mode2: • If there is no signal input for 8 seconds, the
TV enters the standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on automatically.
• The TV turns on again by pressing a on the TV
or B on the remote control unit. (See page 7.)
14
Power Control
TV/AV only
PC only
Setup menu
MENU
[ Setup ]
Setup
Auto Installation
Programme Setup
Child Lock
Input Label
Position
PC Setup
HDMI Audio Select
HDMI Auto View
WSS
4:3 Mode
Rotate
Lanugage
Reset
CAUTION
• When selecting "Reset" in the Setup menu, all menus will be reset
to the factory preset values and "Auto Installation" will activate.
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Auto Installation", and then
press OK.
If you have already set the PIN under "Child Lock",
enter it here.
• See page 16 for setting PIN.
4
Press a/b to select "Yes", and then press OK.
5
You can set language and country the same as in
the initial auto installation. Follow steps 1 and 2
on page 7.
Programme Setup
This section describes how to set up analogue TV
channels manually.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Programme Setup", and
then press OK.
If you have already set the PIN under "Child Lock",
enter it here.
• See page 16 for setting PIN.
4
Press a/b to select "Auto Search", "Manual Adjust",
"Sort" or "Erase Programme", and then press OK.
Auto Search
Manual Adjust
Sort
Erase Programme
Option
TV only
TV only
Yes
No