Crestron FlipTop FT2 Series Manual de inicio rápido - Página 5

Navegue en línea o descargue pdf Manual de inicio rápido para Sistemas de control Crestron FlipTop FT2 Series. Crestron FlipTop FT2 Series 11 páginas. Ac power outlet modules
También para Crestron FlipTop FT2 Series: Inicio rápido (2 páginas), Inicio rápido (2 páginas), Manual de inicio rápido (11 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (11 páginas), Manual de inicio rápido (9 páginas), Manual de inicio rápido (9 páginas), Primeros pasos (2 páginas), Primeros pasos (2 páginas), Primeros pasos (2 páginas), Manual (2 páginas), Manual (2 páginas), Manual (2 páginas), Manual de inicio rápido (7 páginas), Manual de inicio rápido (8 páginas), Inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Inicio rápido (2 páginas), Inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Inicio rápido (2 páginas), Inicio rápido (2 páginas)

FT2-700-ELEC-PTL

FlipTop™ FT2 Series Cable Management System, 700 Size, Electrical, Pass-Through Lid

Connect the Network

Automate the one-touch retractors by connecting all retractors in an

FT2 assembly to a control system and a switch, or to a DMPS via a single

Cresnet® cable. Custom programming can trigger the retractors after

five minutes of no video detected.

Connect the FT2 assembly to a Crestron control system or DMPS3 via

the 3-pin connector using standard Cresnet cable. The red power lead is

not connected and should be terminated.

Connect and Place the Power Supply

The FT2-700-ELEC-PTL ships with one 24VDC power supply that is used

to supply power to the power bus in the FT2 assembly. There are six

possible locations to attach the power supply. Connect the power supply

prior to installing any modules.

NOTE:

Two power supplies are required if installing two rapid charging

modules in the FT2-700-ELEC-PTL. For more information, refer to the

FT2A-CHGR-USBA-BASIC Quick Start Guide (Doc. 8423)

FT2A-CHGR-USBA/C Installation Guide

(Doc. 8219).

To connect the power supply to the power bus:

1. Underneath the FT2-700-ELEC-PTL, connect the power supply to the

bottom of the power bus.

If connecting one power supply, connect the power supply's power

cord to the single connector end of the DC power splitter cable.

Refer to step 1 in

Secure the FlipTop

If connecting two power supplies, connect each power supply's

power cord to a barrel jack in the power bus.

2. Use the two included tie wraps to dress the power cord.

3. Slide the power supply into the power supply holder until it is secured

in place.

Quick Start

Assembly.