Siemens SIMATIC NET Manual de instalación - Página 23

Navegue en línea o descargue pdf Manual de instalación para Equipamiento industrial Siemens SIMATIC NET. Siemens SIMATIC NET 40 páginas. Network components bus terminal
También para Siemens SIMATIC NET: Manual de instrucciones (29 páginas), Manual de instrucciones (50 páginas), Manual de instrucciones (28 páginas), Manual de instrucciones de montaje (6 páginas), Información sobre el producto (6 páginas), Manual de instalación (50 páginas), Manual de instalación (40 páginas), Manual de referencia (14 páginas), Manual de instalación (34 páginas), Manual de instalación (48 páginas), Manual de instrucciones (32 páginas)

Installing the Device

2.3.2 Connecting DC Power

2.3.2

Connecting DC Power

To connect a high or low DC power supply to the device, do the following:

Electrical hazard – risk of damage to equipment

Before testing the dielectric strength (HIPOT) in the field, remove the braided

ground cable connected to the surge ground terminal and chassis ground. This cable

connects transient suppression circuitry to chassis ground and must be removed in

order to avoid damage to transient suppression circuitry during testing.

Using a #6 ring lug and #6-32 screw, secure the ground terminal on the power

source to the chassis ground terminal on the device. Make sure the lug is

tightened to 1.7 N·m (15 lbf·in).

Stainless Steel Stud

#6-32 Screw

#6 Ring Lug

Figure 2.7

Chassis Ground Connection

NOTICE

RUGGEDCOM RS8000T

Installation Manual, 01/2021, C79000-G8976-1023-05